Questions & Answers for: Oldsmobile Cutlass Ciera 12 blinks

Question about 1993 Cutlass Ciera

1 Answer

Both turn signals light, but do not blink Where is the turn signal flasher located for a 1993 Olds Cutlass Supreme S ?Both turn signals do not work.I've changed all bulbs, Checked, changed fuses.turn ...

Ad

Question about 1988 Cutlass Ciera

4 Answers

1988 Olds cutlass ciera trouble codes I have three codes from my car 12, 15, and 34. I can't find the problems that go with these codes anywere. I think 12 is the coolant sensor but I just replaced ...

Ad

Question about 1992 Cutlass Ciera

1 Answer

...Wire Black F Not Used G Headlight Dimmer Wire Gray H Power Antenna Turn On Pink (if available) I +12 Volt Ignition Wire Yellow J +12 Volt Battery Wire Orange K Right Rear Spkr (-) Light Blue L

Question about 1989 Cutlass Ciera

2 Answers

...warm. Can I fix this (even if only temporarily) by adding freon? If so what type do I add? 89 is R-12 unless it has been converted to R-134. If the recharge ports are threaded on the outside than it ...

...3.8 fit a 88 cutless ceria 2.8 I don't believe it will. in 1988, the industry standard freon was R-12. around 93, all GMs were switched over to R-134A. R-12 connectors, charge ports, and even seal ...

not receiving signal from coil packs to engine computer control. showing code 12 code 12 is usually the first code you get and just ignore it.Watch the code after code 12, that's what you ...

confirmed. Other wise there are issues in th wiring harness, If you can use a multimeter check for +12 at the fuses, if absent this must be traced. Use of a 12 volt park lamp bulb will assist to check

...blinks). This is a code 12. A code 12 means the system is working. It will blink a code 12 three times. After the code 12 there will be a litttle longer pause and then another code(s) should start. ...

...sputtering but not quite starting. Then it'd just tu I checked the diagnostics and just got 12 12 12 which I believe means the diagnostics are functioning. there's about 3/4 tank of ...

I have a 1993 Cutlass Cierra. The right signal(turn) lights blink very slowly when turn signal is engaged. All lights, front, rear and corner are burning. All lights blink normally when the hazard fl ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...