...10 amps is more than ideal, but you will probably need less after initial tests. Ammeters need to be in series, not in parallel like volt testers, so disconnect one battery lead(either will do) and ...
...10 amps is more than ideal, but you will probably need less after initial tests. Ammeters need to be in series, not in parallel like volt testers, so disconnect one battery lead(either will do) and ...
...bit easier to handle on the road and easier trails I anticipate riding on. I am 6' with a 33 inseam and it's still hard for me to swing a leg over! I have done a fair amount of suspension work and am ...
...bit rich there.). Now starts much easier and predictably. vince I also have the same bike (08' 530) I installed the 6 days needle (OBDTR) and have it at the #7 position from the top. I also sped up ...
...10 min yak , could not start it using the electric leg , kicked the sh*t out of it got it going. After a couple days kicked her over started fine , cannot get it to start with the elect start , took ...
...10 centimetre split right down the middle i dont think it can be a cheap fix with a weld cos the front sprocket must be sticking out a wee bit cos the chain rubs against the orange clutch and i cant ...
bit of blue smoke ive changed the piston 10 hrs ago its a 4 stroke when you let it idle for a bit then rev it up it puffs a bit of smoke out any ideas would be exelent cheers gus Bad valve guide seals
bit of a joke now i have been running the tyre about 10 psi the vavle nut is tight should it be tight OK this ought to help you, I pulled it from this site: http://www.dirt-bike-tips-and-pics.com/dirt
...bit then just stoped starting. after that i pulled it all back apart and found it was dirty again so i cleaned everything with carb cleaner i even cleaned the filter and the filter box and took off ...
Usually answered in minutes!
52 Questions
45 Questions
33 Questions
29 Questions
25 Questions