Questions & Answers for: Nissan 10 1 1 1

I am curious about the possible negative effects of running my 73 240z with SU carbs on 10% ethanol. All stations are required in the state of Washington to add 10%. I'm concerned about rubber and ...

...in the back as you are probably aware. No 'special' tools needed. I managed it with a a u-joint and 10" and a 6" extensions; the 10" seems about just right, the other not so critical. From the ...

... Turn ignition switch 'ON' and wait at least 2 seconds. c. Turn ignition switch 'OFF' wait at least 10 seconds. d. Turn ignition switch 'ON' and wait at least 2 seconds. e. Turn ignition switch 'OFF' ...

...lost the cover to my fuse panel under the dash and i dont know the fuse order can someone help #1-10 amp SRS (Aribag) #2-15 Amp Air conditioner #3-15 Amp Air Conditioner #4-7.5 Amp A/T TP/Sw

...1.8 liter engine For 1.8L engines, tighten the bolts in sequence, as follows: Step 1: Bolts 1-10 to 22 ft. lbs. (29 Nm). Step 2: Bolts 1-10 to 43 ft. lbs. (59 Nm). Step 3: Loosen bolts 1-10 ...

...I have Nissan Altima 1996 4 cylinders. It has the problem: engine starts and the car moves about 10 minutes. After 5-10 minutes the engine stalls and doesn't start again. However, after 2-3 hours

...work - it is stuck on aquiring signal for over 30 minuites. The owners manual says to wait at least 10 minuites and it should resync but it doesn't. It worked perfectly before th battery was ...

...thousand, two-one thounsand, etc, or usestop watch. The most critical step is step #3....wait 10 sec, instead of 7. 1. Ignition "ON", count to 3. 2. Depress/Release pedal 5 times...hard and

...Forum www.clubfrontier.org > ... > Nissan Frontier Forums > General Discussion Sep 24, 2013 - 10 posts - ?4 authors Do they even light up from factory (I sure hope they do). .... I know he ...

...https://www.clubfrontier.org/forums/.../frontier-running-terrible-after-warm-up-1611... Oct 10, 2014 - 10 posts - ?5 authors Hi Guys, Ive got a 2000 Frontier SE with the 3.3 in it. I was ...