Hello, I have a Echo PE-200 that won't stay

http://forums2.gardenweb.com/discussions/1515495/edger-troubleshooting-wont-start

http://www.buytoolsforhome.com/timesaving-tools/edgers/troubleshooting-your-lawn-edger-when-it-wont-start

Wow! with all you have done it should run. Be sure the switch is on but if you are getting spark, it should be on. I would take it to the echo place for service.

Hi fuel is supposed to stay in the bulb. Its a sealed unit so at least you know its air tight.

Dirty fuel filter??

hi rgiles_5050

Adjust your idle speed with the idle screw located on the carb...if that does not solve your problem then take your carb off and clean it again because you have some debris/dirt in the low speed circuit, this time make sure to blow all the jet holes out with compressed air to blow out any wedged in dirt
Please take time to rate me
Bud

Hi dbooth
Make sure your fuel lines are connected correctly.
Check the drawing below
Please rate me
Bud

Check and replace the impulse line if you haven't already. How did you set your carb screws after the rebuild? Start with them lightly seated and then give each a 3/4 turn out to get yourself started.

Hi, either the carby is flooding and requires a carby kit or the spark arrestor or outlet in the muffler is blocked. Hope this helps, regards Phil.

Hi, there is a wire screen in the exhaust outlet that blocks up with carbon deposits. It can be removed and cleaned with a wire brush. If blocked it will give you the problem you have and also make the blower quieter than it should be. Regards Phil.

sounds like there is dirt in cable sleeve binding cable, try spraying wd40 in cable and working it, if this don't work remove cable and try to work it back and forth with pliers and small doses of wd40, still not working replace cable