Display will not show when tv flips out!

What's the model of your TV?

Stupid question i know ,buut, have you pressed AV on your TV remote !!

Hello,

there is nothing wrong with your screen, the problem is from the flex that connects your screen to the phone's main board. This flex must have worn out that's why your screen is not displaying any picture.

The problem is common with flip and slide phones. The flex gets worn out as a result of constant opening and close of the flip or slide phone.

I would urge you to replace the flex and I am assuring you that your screen will display picture again. You might also be lucky to find out that the flex is not well fix, that is, it may have loosed contact.

If you cannot change the flex yourself, maybe you should take the phone to a local repairer within your vicinity, so that the flex can be fixed/replaced.

Take care.

Hello,

there is nothing wrong with your screen, the problem is from the flex that connects your screen to the phone's main board. This flex must have worn out that's why your screen is not displaying any picture.

The problem is common with flip and slide phones. The flex gets worn out as a result of constant opening and close of the flip or slide phone.

I would urge you to replace the flex and I am assuring you that your screen will display picture again. You might also be lucky to find out that the flex is not well fix, that is, it may have loosed contact.

If you cannot change the flex yourself, maybe you should take the phone to a local repairer within your vicinity, so that the flex can be fixed/replaced.

Good luck.

IF you sidekick 3 screen is blank then the lcd needs to be replaced. Replacing the Sidekick 3 LCD screen is pretty easy and cost about 25 dollars if you buy it from ebay.

Here is a guide for it Sidekick 3 LCD Flip Screen Replacement

and here is a link to the screens

Buy a replacement Sidekick 3 LCD screen.

Your honeywell should have battery back up but the primary power for this is a 24 volt transformer located in the air handler probably in your attic. All these controls run on 24 volts

Bad interface circuit or power supply. Needs servicing..

You most definately have bad capacitors in the power supply. try and get it repaired as soon as possible, not an expensive repair that iv'e seen.

Same Problem. I fixed mine with a baseball bat, hammer, and a cold beer. Lesson learned: NEVER BUY DELPHI AGAIN. NEVER..... Tell your friends. Delphi = POS

The lamp probably needs to be replaced, http://www.samsung.com/us/support/popup/howToGuidePopup.do?howto_guide_seq=45