My inverter keeps going to falt even though i only use it for a few seconds its only a few months old and has not been used mush its a 1000 2000 max

The DC output for battery charging is from the engine alternator and is completely independent from the generator inverter.

As this is an inverter unit the typical polarization techniques for standard generators will not apply.

The ouput indicator being lit means the inverter input output should be good. This further implies a circuit disconnect state at the outlets. Try pressing the overload reset switch to make sure it is not in an odd state.

it indicates an overload situation
not enough information provided as to voltage supplied to the inverter and the voltage of the grinder
examples are for 110 volts ac with a current draw of 4.2 amps the wattage is 462 watts or for 240 v ac with 4.2 amps the wattage is 1008 watts assuming that it is 240 volts and the inverter has a maximum ate of 1000 watts then it is overloaded and circuit protection is cutting in
check the wattage of the inverter and the wattage of the ac units you use and if there is not a 25% difference in favour of the inverter then it is an overload situation

FOR DIGITAL CAMERA BATTERIES MUSH BE POWERFUL LIKE 1000 AMP TRY IT

If your watch is less than 2 years old then they may service it for free, and if it is that new I would take it back to point of purchase for assistance. Even though Rolex's are Chronometers they are not known for their ability to keep near perfect time. If you are losing only 6 seconds a day then you are still over 99% accurate and it does not really get much better than that (that means you may loose a couple mninutes a month. A watch winder that you set your watch in while not wearing can keep it spinning/ winding and therefore may increase accuracy.
If your watch is loosing a lot of time (half an hour a day) or if the watch is more than 5 years old, it likely needs some servicing. Oils can harden and thicken within your watch and this will affect the performance. Rolex recommends servicing your watch every 5 years or so to keep it in peak condition. A usual service entails a cleaning, oiling and regulating; this usually costs from $350 to $700 depending on where you go and if nothing else is wrong with your watch.
But again, if you are only loosing a few minutes a day, then your watch is still in good shape and I would not recommend paying the money to get it to work only a small bit better.

hi i have trace sw5548 and the power keep turning off and i have to go in P G and E power, why would it keep turning off thanks

Sounds like one of two things are happening:

1. Microwave is drawing too much current, causing internal voltage monitoring circuitry in inveter to go into protection mode.

or

2. RFI from microwave is somehow being few into inverter causing similar circumstance.

It's a bad back light inverter. These models are NOTORIOUS for them. It's a simple fix for a technician and not very expensive. I fixed mine about 2 years ago and it's still going strong.
You can purchase replacement inverters and if you're handy with a screwdriver you can fix it yourself.
-=/ Daft Tech /=-

got a cobra cpi 480 inverter it keeps beeping everything runs but produces no power

Even though these are different symptoms, the same part may be causing both.

If the digital programmer circuit / controller does not get a feedback signal from the inverter for a period of 3 seconds, the controller will stop the cook cycle.

If it stops after 22 seconds, that means the controller has detected a problem, usually a problem with the inverter or a bad magnetron.

Due to the lethal voltages used and produced, I do not recommend that an inexperienced person work on these.

You can find an authorized Panasonic servicer here.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.