Honeywell Wireless Personal Weather Station TE109NL is not working. I have changed the batteries.

Your 'figure'??

Normally it has to be done in order. Remove both lots of batteries. Put the base unit batteries in first and then put in the outside unit batteries. they should pair. In fact the manual states that.

Instructions:
- Open the battery compartment on the weather station and insert 2 x AA
batteries, taking care to put them in the correct polarity. Close the battery
compartment.
- Open the battery compartment on the transmitter and insert 2 x AA batteries,
taking care to put them in the correct polarity. Close the battery
compartment.
Note: Ensure to install the batteries into the weather station and transmitter
within the same hour to ensure that they synchronize properly.

DigiTech XC-0366 User Manual - ManualsLib

https://www.manualslib.com > ... > Weather Station

View and Download DigiTech XC-0366 user manual online. Wireless Weather Station With Outdoor Sensor. XC-0366 weather station pdf manual download.

I have two of these and they lose the signal occasionally. Per the manual: Make sure all batteries are good and then press the TX button on the remote sensor for 3 seconds so it sends a wireless signal to the weather station. It should beep. Then on the weather station hold the CH button for 5 seconds to make it search for the transmitter until the outside temp appears. Just removing batteries and reinstalling them in various orders doesn't work. You must re-establish the wireless connection between the outdoor sensor and weather station.

I did a search and could not find anything on that particular model. But I found some things that may help.
Here is a link to a manual for a different weather station by Honeywell that may help. http://www.honeywellstore.com/store/images/pdf/TE242ELW.pdf
If not try their support section:
https://honeywell.com/Pages/contact-us.aspx

Hi,
I always have trouble getting mine to work after changing the batteries, but I have just managed to get it going by doing the following:
taking batteries out of main unit
putting new battery in remote unit and pressing remote unit reset button
re-inserting batteries in main unit and pressing reset button.

i think the trick is to ensure that the batteries go in the remote unit first, then the main unit after that. It has taken me days to work this out!

Hi i need the manual for the above is there some where u could upload the manual to and give a link thanks

Hi,

This problem could arise due to various reasons
1)Replace the batteries in remote sensors
When the batteries are properly installed, the remote weather sensor will resume sending signals to the main unit.To enforce an immediate remote signals search, press and hold
DOWN on the main unit.

2)Remote thermo-hygrometer sensor could be weak in sending the signal about weather Forecast.Test it properly.

3)Reset the unit and check


post a comment for further assistance.
Thank you for using fixya have a nice day:-)