Question about Amana Heating & Cooling

1 Answer

Do u have to remove the styrofoam in the inside?

Posted by Anonymous on

Ad

1 Answer

Randy Cady

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

No. Do not remove the styrofoam.

Posted on Jul 26, 2011

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wine Enthusiast 18 Bottle Model front panel wont stop beeping. been told I need a part. How to do you remove the inside styrofoam.


The foam is glued on,so you will most likely destroy it trying to remove if you don't be careful.

Aug 13, 2018 | Cars & Trucks

1 Answer

I thought the styrofoam inside the dehumidifier float was packing material & threw it away. Now my dehumidifier gets too full before the "full" sensor comes on. Can I replace the styrofoam?


Hi Kim - I understand that you removed the styrofoam inside the dehumidifier float thinking it was packing material, however I would recommend contacting the manufacturer to verify if it the part is available and can be replaced.

Sep 05, 2012 | Frigidaire FDL50R1 Dehumidifier

1 Answer

I have a whirlpool refrigerator, model GR9FHMXPQ. I got it about 4 years ago. When it was delivered, it had several pieces of styrofoam lodged in the inside ceiling of the fridge section (below the freezer...


You need to remove all of the styrofoam packing material.
Any insulation material would be installed inside the body of the fridge/freezer. The packing material is there so anything inside the compartment (like metal shelves, plastic holders, etc. don't bounce around during shipping and either scratch up the interior, or break. That is all that it is there for.

Apr 25, 2017 | Whirlpool GR9FHMXPS Stainless Steel Top...

1 Answer

Water draining in bottom of refrigerator


Unplug the refrig . Inside the refrig section , remove the 4 screws ( 2 on each side ) and
lower the panel . Disconnect the large plug and remove the panel by pulling froward to
clear the defrost drain hole .Find a food safe caulking or odorless silicon and caulk at the
upper portion where the styrofoam meets the plastic AND on the top center of the styrofoam (
all the way around the large rectangle hole ) so that the styrofoam will seal to the top of
the refrig . When the refrig goes into defrost , the water is seeping between the refrig top
and the styrofoam , causing it to run into the refrig section . When reassembling , be sure
to plug the large plug back into the refrig .

May 28, 2010 | Frigidaire FRT21H8 Top Freezer...

1 Answer

Locationfrigidaire frt18s6aW


Unplug the refrig . Inside the refrig section , remove the 4 screws ( 2 on each side ) and
lower the panel . Disconnect the large plug and remove the panel by pulling foreward to
clear the defrost drain hole .Find a food safe caulking or odorless silicon and caulk at the
upper portion where the styrofoam meets the plastic AND on the top center of the styrofoam (
all the way around the large rectangle hole ) so that the styrofoam will seal to the top of
the refrig . When the refrig goes into defrost , the water is seeping between the refrig top
and the styrofoam , causing it to run into the refrig section . When reassembling , be sure
to plug the large plug back into the refrig .
While the panel is down , use a hose inserted into the opening of the drain hole on the rear
wall , to blow thru to remove any unseen blockage in the drain line .

May 27, 2010 | Frigidaire Refrigerators

1 Answer

Need to access inside of Carrier air conditioner.


After removing the cover and filter, you should be able to see the fins for cleaning. If there is styrofoam in front of the coil, it should not be there for proper operation.

Aug 20, 2009 | Carrier 52FE312-3 Air Conditioner

1 Answer

IS THERE SUBPOST TO BE STYROFOAM INSIDE THE AIR CONDITION, IT IS BEHIND THE FAN WHEEL, AND ON BOTH SIDES INSIDE UNIT WATER RUNS OUT THE FRONT, NOW UNIT DOES NOT TRUN ON. THANKS, DEE


Yes to the Styrofoam , If there is water running out the front of the system your drain is blocked and or the system  needs to be removed to inspect the drain tray and clean out if required.(serviced). As for it not turning on , check that the fuse isn't blown as the water may have shorted the controls wires and blown the fuse

May 10, 2009 | Haier 5200 BTU Window Air Conditioner...

1 Answer

Styrofoam inside of my Haier HWF05XC7


It should remain there it is the insulation seperating the condensing side from the evaporating side you may nve to reach in and move it around to prevent the destruction of the foam.

Jun 22, 2008 | Haier Mechanical Air Conditioner HWF05XC7

2 Answers

Styrofoam inside


you may open and remove foam not included in unit , be sure return make align everything.

Jan 01, 2008 | Kenmore 335 CADR Air Purifier

Not finding what you are looking for?
Heating & Cooling Logo

Related Topics:

198 people viewed this question

Ask a Question

Usually answered in minutes!

Top Amana Heating & Cooling Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Dennis Boxerman

Level 3 Expert

1303 Answers

Brad Scarpetta

Level 2 Expert

104 Answers

Are you an Amana Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...