Washer won't unlock flashes f14.....Kenmore Elite HE4t

torque bit, I'm not sure if its size 27 or 25 but its definately a torrue bit

If you need further help, I’m available over the phone at https://www.6ya.com/expert/jason_4570d45317834dd3

Try this site:

http://adsisecurity.com/KenmoreWasher.htm

I have a Kenmore Elite he4t front load washer that was working fine and then we moved and now it stops washing midstream and flashes an F and a H. I have to pause and restart then it will stop washing again after a few minutes and flash the same codes again. I reset again and then it stops with 1 minute left and will not drain.

The following link explains how to correct a Control Lock problem on a Kenmore Elite:

http://www.fixya.com/support/r2469429-kenmore_elite_amp_whirlpool_duet

Your control panel options may differ slightly from the instructions I have posted, but the instructions should be listed on the front panel. If this does not correct your problem, you may have a more serious issue than a simple operator control problem.

If you have any questions, or require additional assistance, please let me know. I hope this helps you.

"F06" is a Motor Speed error. The following link explains how to troubleshoot and some common causes:

http://www.fixya.com/support/r714929-f06_error_whirlpool_duet_kenmore_elite

The first step to troublehsooting should be to unplug the washer for AT LEAST 30 minutes in an attempt to reset the Central Control Unit (CCU). Sometimes this is all that it takes to correct momentary glitches with the unit. If the error code reappears following a computer reset, follow the advice given in the link I provided.

If you have questions, or require additional assistanc, please let me know. I hope this helps you.

The motor controller board is likely bad.


Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.

121 MINUTES USUALLY DRAIN CYCLE PLZ REMOVE 3 BOTTOM PANEL SCREWS 7 MM SCREWS, TO OPEN DOOR SLIDE RIGHT HAND TOWARDS DOOR LOCK ,THERE WILL BE A SMALL LEVER TOO PULL DOWN ,NOW ITS OPEN,,, SINCE U HAVE BOTTOM PANEL OFF PUMP IS RIGHT IN FRONT REMOVE PLASTIC HOUSING CLOCKWISE ,,,REMEMEBER HOLD 3 GALLONS OF WATER STILL ,HAVE BUCKET READY ,NOW CLEAN OUT PUMP AND DEBRIS ,, CLOSE IT UP SHOULD BE FINE NO MORE PROBLEMS ,,,,,

F14 = EEPROM Error

The Central Control Unit (CCU) receives it's data from an EEPROM on board the CCU.
If there is an error reading this data, it will cause this error.

A power glitch may cause this error. Try unplugging the Unit for two minutes to see if that fixes the error.
Check CCU

So its likely you'll need a new CCU board. Check your owners manual, some models have up to a 5 yr. parts warranty on that CCU.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

Get the same code 2 minutes into cicle. F H