Sony Cyber-Shot DSC-T1 Digital Camera Logo

Related Topics:

Question about Sony Cyber-Shot DSC-T1 Digital Camera

1 Answer

Is this normal or a malfunction?

When I turn on my sony t1 it makes two clicky sounds (one after another). I am not sure if it made the sound when I first bought it or it just happened. I can still return or exchange it. Please help me if you can!!!

Posted by Anonymous on

Ad

1 Answer

Anonymous

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Its normal. its something to do with the lens focusing and switching on and everything so nothing to worry about

Posted on May 29, 2007

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Having problems with car starting. Battery is good, iol recently changed, although was very low prior to change. Also had transmission fluid flushed. The car sounds like it wants to turn over, but...

http://www.fixya.com/cars/r7030578-engine_turns_over_but_wont_start

IF your engine is turning but not starting, try the above link to my tip.
IF youre not even getting the engine to turn over, the click you hear, may be the starter trying to throw the gear out to engage the flywheel (sounds like "clunk"), or if is a rapid ("clicky-clicky') sound, that's you're starter relay under your hood in you're realy/fuse panel
2helpful
1answer

I have a Sony DSC-T1 and it is displaying a flashing error message E61:10. . The screen is blurry and I can't do anything! It had the CCD chip replaced by Sony free of charge previously - is this the same...

Hi,

In DSCT1 Camera, the E:61:10 error message indicates a Self diagnostic message. This message can be clearly identified by the help of a Sony Authorized service technician. Each of these codes indicates the symptoms and resolutions of the Camera. The E error code indicates the internal hardware malfunction with the Camera. This issue is not related to the CCD Image Sensor replacement.
Try the steps given below to check if the issue can be resolved.

· Turn off the camera.

Remove the battery pack.

Press and hold the power button for 30 seconds.

Allow the camera to remain without power for 60 seconds.

Reinsert the battery pack.

Turn on the camera.
Also, try resetting the Camera back to factory default by pressing the RESET button using a sharp-pointed object. The RESET button is located at the lower right side of the control buttons.
Please make sure that the Camera is turned ON before you reset it.

Good Luck!!


0helpful
1answer

Internal speaker stopped working on my ipod 5th gen, headphones still work tho.... anyone got the solution??? cheers

Well, the internal speaker does not play sounds... It is not possible for the iPod's internal speaker to play music, as it is only capable of making three disctinct sounds:

the clicky noise

the alarm sound

the chirpy noise when you boot into diagnostic mode


You can get those sounds back by going into SETTINGS on the IPOD and turning the sounds back on.
1helpful
1answer

When ignition is switched on their is a whirring sound and engine wont turn over.and start.

It sound like the lobes on the starter's shaft have worn down and aren't making positive contact with the flywheel anymore. A "whirring sound" would be the starter motor spinning but not "catching". If it's a clicky/buzzing sound then it would more likely be the starter solenoid, low battery/bad alternator.
The "whirring" sound should still be winding down for just a second after you turn the key off. The "buzzing" symptom will stop instantly when you turn the key off.
0helpful
1answer

Sony t1 pictures are now all washed out. old pictures can be viewed normally on the camera from the same memory stick. This happened once before then went away. Now it appears to be a permanent condition.

This is CCD Imager failure problem in Sony DSC-T1 camera and ccd imager chip will be replaced to correct this issue.
Sony offers free of cost repair for ccd problem in DSC-T1 camera.
Click Sony CCD Imager Support for details.
3helpful
1answer

Hi I have the sony cyber shot dsc T1. The battery is fully charged. when i flip the front panel down to operat ethe camers the screen is black but still showing (battery strenth, minutes left, folder...

This sounds like a description of one symptom of a failure with a ccd imager chip that I just received from Welcomejee. Reading the document at the below link describes a black screen, a test you can use to see if that's the problem, and if so, you can mail the camera to Sony for a free repair. Here is Welcomejee's response:
"It is failure of ccd imager chip in your Sony DSC-T1 camera and Sony will repair it free of cost.
Click Sony CCD Imager Support for details."
1helpful
1answer

Cyber Shot DSC-T1, Possible CCD Problem

Hello,
When ccd imager is defective, picture result on still image and video get bad in either cases.
Your camera problem is some thing different and hardware failure is possible like data processing IC but in any case, digital processing board has to be replaced and I'm sure its price would be above and over the camera worth.
You can give try by removing and plugging back the flexible wire board ( ribbon) of lens and ccd imager attached to circuit board. Be careful when handling as flexible wire board can be damaged easily.
Thank you.
0helpful
1answer

Faulty DSC T1""

This sounds like it might be a defective CCD imager. If so, Sony should fix this for you for free, including free shipping both ways. This is regardless of your camera's warranty status. Please check the following link for more info:

http://camerarepair.blogspot.com/2007/11/sony-konica-minolta-cameras.html

Contact these service centers and state that you want your camera repaired as per the advisory:
http://www.sonyservice.co.nz/servicesupport_map.asp?sm=1

Applicable cameras include:
Cyber-shot DSC-F717, F88, P10, M1, P12, P2, P31, P32, P51, P52, P7, P71, P72, P8, P92, T1, T11, T3, T33, U10, U20, U30, U40, U50, U60, V1

CD Mavica MVC-CD250, CD400, CD500, and FD Mavica MVC-FD100, FD200
0helpful
2answers

Sony T1 problem

Sounds like this camera needs reprograming, this can only be done with computer program (Sony Seus) available only at your Sony Dealer service center
Not finding what you are looking for?

30 views

Ask a Question

Usually answered in minutes!

Top Sony Cameras Experts

Cindy Wells

Level 3 Expert

6450 Answers

WTF Chuck.....
WTF Chuck.....

Level 3 Expert

388 Answers

Are you a Sony Camera Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...