Hx 2415 Beam receive and transmit

Microsoft Windows for Pocket PC 2003 is the software on your hp ipaq hx,
Here is the link for it:


http://www.microsoft.com/downloads/en/details.aspx?FamilyID=9996b314-0364-4623-9ede-0b5fbb133652

If I could be of further assistance, let me know. If this helps or solves the issue, please rate it and give a testimonial for my response.

Thanks, Joe

I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309

this refers to the infrared transmitter. Some printers and other devices have infrared receivers to collect the information you would be sending without wires (this was done prior to wi-fi and is installed on many PDAs for legacy support. I would venture a guess that 90% or more of the people who own devices with the transmitter do not use it.

Have you tried a hard reset (deletes everything)

1. Press and hold down the Calendar and iTask buttons.

2. While holding down these buttons, use the stylus to lightly press the Reset button on the bottom of the iPAQ Pocket PC for about two seconds.

3. When the Pocket PC screen begins to fade, release the Calendar and iTask buttons first, and then remove the stylus from the Reset button.

4. The Pocket PC resets and powers on.

Recovery Procedure for HP iPAQ hx2750, hx2490, and hx2790 Pocket PC Series:
To perform a Hard Reset on the iPAQ Pocket PC by pressing and holding the Calendar and iTask buttons (1 and 4).
2. While holding down the Calendar and iTask buttons, use the stylus to lightly press and hold the Reset button, which is located at the bottom of the iPAQ Pocket PC, for approximately two seconds.
3.. Release all buttons.
4.. Connect AC power to the iPAQ Pocket PC. The handheld Powers On,
performs the normal boot sequence, and automatically restarts system.

Click the square of receieve all incoming beams in blutooth setting

go to
File explorer
My device/windows
start menu
Program
delete the icon(s) you don't need

On your iPAQ, locate a file you wish to beam. Tap and hold the stylus on the file, you should get an option to "Beam File" Make sure your fairly close with other device when beaming files.

You're probably going to have to set up an ActiveSync connection between your PC and your 2415, then run the program installer on your PC while you're connected to the iPaq.

what device are you trying to send to. I know that with my phone, I have to set it to discoverable before I can send a file.

Well, the standard tricks include: * always turn off WiFi and Bluetooth when not in use * turn down Backlight as much as you're comfortable with, and set it to turn off at a reasonable interval if nothing's happening * get a screen on/off toggle so you can turn the screen off if you''re listening to music. Actually, most of the audio software includes a screen toggle function; but you may want a general one in order to turn the screen off if you're recording, say. I'm sure other participants will chime in with more advice. If a card's in, it's on. I don't think it draws too much power.