Hi I have a Tricity Bendix TM320W and it only blows cold air is there anything i can do to fix it? Thanks

bad heater element or fusible link in manifold

My dryer stop heating up IV check water tank cleaned vents but still not heating up can you tell me if there a reset button on it please

get a air compressor at the drain end and blow air up the hose to try unblock what ever could be over the sensor. OR get your garden hose and force water the other way to try unblock

Hi, I have a very similar issue with you guys. My tricity bendix washes ok but doesn't heat up when drying. It's cold. Does anyone know what part I need or how to fix it?

Possible that the INLET valve is faulty /clogged or there is no voltage to switch ON the inlet valve.
So measure the voltage at the inlet valve, also check if the inlet filter is clogged.
Check the water pressure at the inlet to confirm, remove the line from the inlet valve and confirm the flow when activated.

Hi from retired Englishman in SW France,

You will need to type into your search engine/web browser '(make model number) washer manual' and you should be presented with a number of sources from which you can either download for free or have to pay a nominal amount.
You could also try the manufacturer's web site direct ;-0)

If this has assisted you please consider a 4 thumbs up for the rating.
Thanks and good luck!
John C.

hi,
This is due to falty thermstat or heating element.

Please try here:

http://www.serviceforce.co.uk/pdfs/U23248.pdf

If this is your model (there are 5 models with the same name) please rate my response.

If not, please let me know and I will find the link for your model.

Thanks.

check brushes in motor

Check the fan that is supposed to blow the hot air into the drum. It may be seized or jammed. It should be situated on the top of the outer drum. You will need to remove the top cover from the machine and identify the blower fan.