LG ld-14aw2 dishwasher

IE is inlet error, displayed when "Not reached to the normal water level in spite of 10 min. water supply"

Possible cause:

• The Water Supply Tap is closed.
• The Water Supply is shut off.
• The Inlet Hose is kinked.
• The Water Pressure is very low.(below 10 psi)
• Inlet Valve is OK?
• The filter of Inlet Valve is clogged by impure water.
• The Hall sensor is OK?
• The Impeller of Air Guide is bound.

• Take action on Water Supply device.
• Measure the electric resistance of Inlet Valve. (950-1300 )
• Clean the filter of Inlet Valve.
• Check the frequency of Inlet Water by the Test Mode.
• Replace the Air Braker.

My LG LD-14AT2 Dishwasher started flashing IE recently which is supposed to indicate a lack of water. When started it would let water in then after a couple of minutes start flashing IE and pump the water out again. After dismantling most of it to check the wash motor I found the motor start capacitor had overheated and had some of its inards hanging out. I've ordered one online from [email protected] (about $20) including delivery. The motor turned freely with pump attached so I'm hoping this will fix it. The capacitor is at the right rear of the machine and is rectangular with a tab for fixing it to the chassis and has two push-on tabs for wire attachment.