Its a 2004 61 inch big screen projection tv and the subject on screen has three colors outlining it green red blue on the outer portion of subject on screen

the color tv display used mixing of three colors, (red, green and blue). it lost one color, coomon problems: lose contact of base of picture tube or its wiring, sockets, capacitor dead in rgb section, dead video ic

THREE possible reasons for this:
I will list each and describe for you:

1.) If redish picture go to a black and white channel; is the screen somewhat red or black and White? This is adjustable from inside the set.

2.) If colors are skewed or look like they have a red outline it may be a convergence problem. See attached photo.

3.) Some of these sets develop a problem with the coolant which is used to keep the face of each of the three tubes cool; it is called Glycol. You would have to remove back cover and with set on look into each of the three lens (red,green,blue) to see if you have a clear red, green and blue picture.

Which best describes your problem?

SD TECH

that means that the phone needs to be unlock by the network provider

For CRT projection TV's, this indicates that the Green picture tube is burned (warn out). The less green that strikes the screen, the more redish the image will look. You will need to find an old school TV repair shop that knows how to replace picture tubes.
In the case of a DLP style TV, the color wheel needs replacing.

Sounds like your convergence chips have failed. This is a common problem. You can get a repair kit from www.TvRepairKits.com .

It sounds like bad solder connections in the convergence output circuit. It may also be an intermittant convergence output ic which will need to be replaced.

Projection TV sets have several common problems listed below.

Problem #1) Convergence

Symptoms:

• Screen Looks 3-D
• Colors wont align
• Screen may look distorted
• No Audio/Video - makes a chirping sound.

Example Photo:

Problem #2 CRT Fluid has clouded over.

Symptoms

• Dull Video, Washed out
• White/Bright looking video
• Halos around objects
• Red/Orange looking

Example Photo:


You can see more examples and find a fix here...

http://www.fixya.com/support/r2861467-solution_video_looking_whiteish_dull

hi you have faulty convergance ic also there may be some faulty resistor and capacitors that sit in front of the ic, thanks

shaun

Needs convergence amps replaced. Sometimes resistors burn and need to be replaced. This repair requires soldering/desoldering equip. and a trained eye, but usually can be done for 175.00-325.00 at a reputable service center. Good luck, Russmann.

If it is truly a 52 inch standard projection set (you have it listed under 32V420T which is not a projection TV) and your 3 colors (red, green and blue) are no longer lining up and are all curved on the sides, then it means that your convergence power supply has stopped working. Post the actual model and chassis number and a better description of the picture here and I will be able to assist you further.