We have an older Furuno 1621 mk 2, is there anywhere I can down load an operators manual. Thanks

Service and Owner's Manual.

FURUNO 1622 SERVICE MANUAL Pdf Download ' ManualsLib

https://www.manualslib.com > ... > Marine Radar > 1622
View and Download Furuno 1622 service manual online. Furuno 1622 Marine Radar Service manual. 1622 marine radar pdf manual download.

• 
  

  FURUNO 1623 OPERATOR'S MANUAL Pdf Download

  https://www.manualslib.com > ... > Marine Radar > 1623
  View and Download Furuno 1623 operator's manual online. Furuno Marine RADAR User Manual. 1623 marine radar pdf manual download.
  
  ..

Hi Bruce

It has been my experience that Furuno doesn't part with their schematics cheaply. If you contact their support department, they MIGHT sell you a schematic, going price is usually about $100. Here's a link to their support/forum page.
Good luck.
-Steve

http://www.furunousa.com/Support/default.aspx

Hello?

vorrei se e' possibile avere il manuale in irtaliano del radar furuno 1621,grazie

It doesn't appear to cover the ham bands, only maritime. This radio is also not type approved for operation on ham bands either.

You can find the freq. range in the manual at the link below:

http://www.furunousa.com/Furuno/Doc/0/AHHEA1GA2ITKN04R23GBMOTKF1/FS1502%20Operator%5C%27s%20Manual%20Vu.pdf

Nice Radio though.

You may have a faulty magnetron or one that has gotten old. They do have a life. Find out how many hours you have on the unit and give furuno a call. They will more than likely tell you what they think the problem is.

With a voltmeter, verify that you are getting 12V at the plug end of the power cable. If so, check the fuses (there should be one or two fuse holders on the back). If all of that fails you will need to send it in to Furuno for repair.

if you have the part #, call 847-746-0100, I will order it from Furuno for you.

I have the original manuals.....

I had exact the same problem with my furuno 1621, Furuno in Netherlands also say needs new mother board (650 euro!)

Problem is fixed

Problem is not the switch, but an Elco on the mother board. it's the small elco on the Mother board Cost just a few cents!

I hope You can fix Your radar too.

Erik Jansen

[email protected]