Just purchased ativa MD 460C and it will not work. misaligned is highlighted. can u help solve problem?

If the auto shred function on the MD 1250 persists without stopping, potential causes include sensor misalignment, paper jams, software glitches, manual control issues, or power supply irregularities. Refer to the user manual for troubleshooting or contact the manufacturer for assistance in resolving the iss

You have to ask the seller because FIXYA doesn't sell products

Robert,
Double check that you do not still have any paper that may have become stuck in front of the sensor for the auto shutoff. If there is something in front of the sensor it will keep running.

Just pull the waste container out and dump it and reinstall it and make sure it goes all the way back in.

i have md 10000 camera it 's lcd back light not work
M_ LCD5V not pass on main borde please help me solved My main bord

ativa md460 misaligned Questions & Answers - Fixya

www.fixya.com > Forum > Tags

Find solutions to your ativa md460 misaligned question. Get free help, tips ... I have an Ativa MD 460c paper shredder that reads misalignment. What do I do?

Just purchased ativa MD 460C and it will not work. misaligned

www.fixya.com/support/t9496803-just_purchased_ativa_md_460c

Jun 16, 2011 - Look for a curve in the lip on the back of the shredder and align it with the ... I have an Ativa MD 460c paper shredder that reads misalignment.

Ativa MD460 paper shredder: misalignment light is on - Fixya

www.fixya.com/.../t7580117-ativa_md460_paper_shredder_misalignme...

Jan 1, 2011 - I have a Ativa MD 1000 that I just bought. It ran for a few minutes the first time I used it an then stopped. I turned it off and unplugged it in case it had ...

Office Depot Ativa DQ60M Shredder Misaligned - Questions ...

www.fixya.com > ... > Office Depot Ativa DQ60M Shredder

just purchased ativa MD 460C and it will not work. misaligned is highlighted. can u help... I have an Ativa MD 460c paper shredder that reads misalignment.

I have a Ativa MD 1000 that I just bought. It ran for a few minutes the first time I used it an then stopped. I turned it off and unplugged it in case it had overheated. The temperature light did not come on. I wait for over 30 minutes and tried using it again. I was able to shred a couple of sheets of paper and it stopped again. The next morning I couldn't get it to work at all. The green ready light is on but the shredder will not start. I can't tell if anything is stuck in it. How do I getting running?

There are three reasons why:
1. paper particles or oil are still causing the optics to think you are inserting paper. Remove cover and clean thoroughly!
2. Optics are misaligned.
3. Optics are defective.

This is how a got my hard to fine gear!

Contact Michael Business Machines for your local dealer 1-800-223-2508

Good luck, Tom

Pull out as much of the paper as possible. Then spray some window cleaner or similar on whats left to soften and disolve it.