Jenn-Air JDS9860AAW Touchpad display error F-7

Hello,

The FO error codes means that a button on the touchpad has shorted out and teh touchpad needs to be replaced. In some cases you will get that error code because the ribbon cable on the touchpad hasa loose connection at the clock. check that the connection is tight.
The error code can be cleared by pushing the clear/off button,if it returns the touchpad will need to be replaced.

GENE

The F1 error code means that the computer thinks a button on the touchpad is stuck. Sometimes this can be resolved by making sure the touchpad connector fits tight into the control board. The F1 code can be cleared by pushing CANCEL/OFF. If it returns the touchpad needs to be replaced .

You might find an answer here:
http://steprightupmanuals.com/oven-and-range-service-manuals/jenn-air-oven-and-range-service-manuals/jenn-air-jgs8750-jgs8850-range-service-manual
prem

Hi


Thanks for using FixYa. Error F7 on your Jenn Air means that the keypad is shorted or stuck and to resolve this issue you’ll have to replace the touch pad/clock assembly (ERC). Please do rate the solution if the issue is resolved or post a comment for further assistance.


Thanks
Rylee

its confused. the problem maybe in you touchpad menbrane

HI, F1-7 IS A BAD CONTROLER RIBBON.CHECK THE RIBBON FROM THE TOUCHPAD TO THE CONTROL BOARD. IF IT LOOKS TIGHT, CONTROL BOARD IS BAD.GOOD LUCK!
ERIC

If you need further help, I’m available over the phone at https://www.6ya.com/expert/dude_653d05454b389bba

http://www.applianceaid.com/fault_codes.html

I have had similar problems:
Display was the Part # 71001799 circuit board..$175+labor
Oven blower problem was control relay board, part# 12001689...$224+labor
My solution. replace with non-Jenn Air.
Check Consumer Reports. Jenn Air has high repair history.

I have a jenn air SVE47600F.It just started beeping and giving a code 7.None of the controls work when it brings the code up,but controls work fine when code is not there. We have to turn the breaker off to reset it.Sometimes when we have been gone all day we'll come home and the range will be beeping and flashing a code 7

From what your telling me, you have tried all the numbers and only 1,4 and 7 beep when touched. Also, the timer display was set at 0:00 when you started. Also, you followed the manual's instructions first, and looked in the back of your manual in the trouble section, and found no answer. 
Did you timer ever work? If not, you should be able to a free replacement of the control panel module from an authorized Jenn-Air repair company. It may be a good idea to contact Jenn-Air first.
The timer shows only hours and minutes when first started. For example 2:05 is two hours and five minutes. It goes into the seconds mode only during the last minute.