Hx2490b i don't have my access codes. how do i reset to factory specs?

The only code would be a parental access code. A Factory Reset should erase it.

https://www.google.com/search?safe=off&rlz=1C1QJDB_enCA643CA644&sxsrf=ALeKk03R0XpUWwKT7YMdfpJExtl5iKGp6w%3A1609456739589&ei=Y1zuX864I6-b_Qbty6e4DQ&q=westinghouse+cw40t2r+reset+code

..

you don`t say did you clear the code after repairs as if not codes will stay in system on some computers. sometimes also you have to use factory convertors as after market ones don`t seem to be built with the same strict specs and don`t work as well. you will have to get it checked out to find what is causing your problem, meaning testing of components. sometimes a problem with the computer will cause this.

You don't have to pay a dealer anything

You do have to go there to get the factory
code,then you can change to whatever you want,
if you have an owners manual or they write it down
for you

Not a reset code,just a security code

Try This:

Enter the SSID pass code. If that does not work reset your D-Link to Factory Default settings

See Blow:

1. Turn off the router

2. Locate the Reset button on the back of the router.

3. Use a paper clip to press the Reset button and power on.

4. Hold for about 5 seconds (don't hold too long) and then release. (Or, release when M1 and M2 flash at the same time.)

5. After you have completed the above steps, the router will be reset to the factory default settings

It will have a reset button on it, hold it down for ten seconds and it should reset the router to factory.

Sorry,but the factory code always works.Ford may be able to change it,though. don-ohio

Hold the reset for 60 seconds, you should have a factory setting. Google the password for the factory setting.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/robert_573a00ba7e399076

Take the phone into your carrier, they may be able to unlock it.
worst case scenario they will backup your information and perform a factory reset.
The purpose of a lock code is to stop people accessing your phone, they make it so its hard to work around.
Good Luck!

Hi!

From your owner's manual, to reset to factory defaults (Page 34)
http://www8.garmin.com/manuals/eTrexVenture_OwnersManual.pdf

Select the route page options button and press the Thumb Stick in to access the options menu.
Select "Restore Defaults" and then press in on the Thumb Stick to restore factory settings.
Hope this is of some help to you.
Good Luck!

Try using your finger to calibrate the screen at first. (If you have difficult to navigate to the alignment screen use the stylus & keyboard to feel out your way) when calibrated to an accepable degree use the stylus to calibrate the sreen, if the target doesn't respond to stylus at any specific piont use your finger. Continue this process till u get it aligned as best as possible. I suspect this problem is caused by specific points on the screen going bad.