No steam no hot water - Breville Fresca BES860 2Cup Coffee Maker

http://www.fixya.com/support/t22011503-gaggia_titanium_plus_no_steam_or_hot

There is a blockage in the steam/hot water circuit . Try poking the end of the steam tip on wand with a paper clip. Make sure turn the hot water on by pressing the hot water button and turning the steam wand.

It probably has mineral deposits inside from the water. This build up of mineral deposits prevents the water from heating up to a high enough temperature. So instead of hot steam, you get hot water.

Fill the water tank.
- Turn the program selector to "On with
light" and place containers below the
hot water dispenser and the steam
nozzle.
- Press the hot water button, turn the
steam selector counterclockwise
and let water run out until it streams
steadily.
- Press the hot water button again.
Turn the steam selector to "o" to shut
off the water.
ENJOY YOUR COFFEE

Normal, depending on the amount, when the hot water goes through the coffee and the pressure builds up the excess has to go somewhere when it stops, usually the drain tray, so there is a little steam loss.

- Make sure that the filled water container is in the appliance.

- Turn the program selector to "On" with lighting and place a container under the hot water spout and another

under the steam spout.

- Press the hot water button, turn the steam selector counterclockwise and dispense hot water until it flows in

quiet, continuous streams.

- Press the hot water button again.

Turn the steam selector clockwise to o, to turn off the water.

If this doesn't do it for you, you are doing it wrong!

Check the 2 limit sensors on the boiler.

Gasket on steam valve is worn. Replace gasket and or steam valve.

kindly please wait...

You're supposed to wait for the blinking light to go solid before attempting to steam your milk!
Until then, the water isn't hot enough (it's at coffee-brewing temp, not steaming temp) to produce steam.
Further, after steaming, the water is too hot for coffee's correct brewing temp, and the light again blinks until it has cooled down enough, if you care.