STARTS PRINTING AND PAPER GETS STUCK HALF WAY THROUGH. THE PRINTER IS ONLY 3MONTH OLD, HOW DO I FIX THIS.

Few thoughts of thi gs I would try.
Click on Windows icon, then on Devices and Printers. Right click on your printer and then properties. Click ports tab. Check to see that the "Enable bidirectional support" checkbox is UNCHECKED. If checked, uncheck.

If this does not fix the problem, do a hard printer reset. Then a solt printer reset. The reinstall the driver.

Try using regular paper on unit as specified by Samsung. If that does not resolve the issue then the hassle lies with the paper feed mechanism. Often a good cleaning of all the rollers in the path can take care of the issue.

If you print single page ?

Generally this is caused by something getting stuck on the print head. You can try a q-tip or a q-tip with pure rubbing alcohol on it and wipe of the print head.

I don't know what is the model of your printer but first you have to clean the pickup roller, because the paper sheet is getting late and the printer just stops printing. Other reason must be the damaged paper sensor (maybe in fusing section) and it has to be replaced.
First try with cleaning ...and clean it well!!!
good luck
pifonski

If there is no direct symptom of paper jam and still you cannot do printing properly, find whether it is because of drum problem. If the paper gets into the end gear of the rotating drum and gets stuck there, you cannot access the printing function. Switch off your printer and check the plastic arms of the printer drum. If there is any paper piece jammed in any of the arms, you can't continue printing. Here also cleaning is the best method to solve the problem. While cleaning, check the arms of the rotating drum. get more information to fix brother mfc printer paper jam problem .

Hey there!!Make sure that nothing is stuck inside the printer like a piece of glass or something!Pick up the printer and tilt it over and shake it,see if anything falls out!!Good luck!

check the paper path. there might be an old scrap of paper that's impeding the flow.

Suggest a small piece of paper or dirt is stuck in the print path near the print heads. Use vacuum tube to **** out any dirt

This is more of a workaround than a fix: I open up the front door and use the Face-Down Tray to collect all my printouts.