Question about Inverter 1000-2000w Peak Surge Power

1 Answer

Can you daisy link two inverters together positive to positive neg to neg ac out to increase the watts

Posted by thesparrow on

Ad

1 Answer

Jeff Bonvallet

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 41 Answers


This will cause big problems. It will not work and will likely cause both inverters to fail. Power inverters must create the 60Hz sign wave from a crystal controlled internal frequency driver. It's like a clock that keeps the timing at 60Hz. 2 independent units will have slightly different clocks both in time and frequency. This would cause the output waveform of one unit to be out of phase with the second. If they are out of phase, they will look like loads to each other and likely fail. It would be possible if the inverters had a way to link their clocks or use only one clock. This could be designed in however I have never seen this feature. You can hook up multiple inverters to the low voltage side (12VDC), just don't hookup their 120VAC output side. Hope this helps.

Posted on Jun 07, 2011

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Aims 2000 watt power inverter will not turn on. i have it hooked in series to two 12 volt batteries and when i flip the on switch nothing happens


try parallel .
negative battery one to negative battery two
positive battery one to positive battery two
all positives to inverter positive
all negatives to inverter negative

Why ?
if batteries are in series you are adding voltages so inverter gets 24 volts when it is rated at 12 v to 16v but two batteries in parallel increases the current available and capacity but keeps voltage at 12 v

Mar 20, 2018 | Inverter Electronics - Others

1 Answer

Overload light eu3000 comes on with trailer roof ac never did before


The battery is really only there for the electric start. Put a digital volt meter on it while running it under the load of the AC unit. Or if it goes off on the overload with the AC unit, try a variable load like an electric heater or two that you can switch on in steps. Most space heaters or hair dryers have a 1000w, 1250w 1500w so you can increase the load. Watch what the voltage does. If at 1500-2500 watt load the voltage starts to drop drastically, say from 125v down to 90 or 80v as the load increases, that usually indicates a problem with it not getting enough fuel. On these inverter generators, the carburetor is controlled by the inverter by the use of a throttle motor. As the inverter senses the demand for more power, it increases the throttle to deliver more horse power of the engine, thus meeting the demand for more electrical power out.
I have seen a couple things cause this. A partially plugged jet in the carburetor can cause it. A bad throttle motor (Part# 21) on the top of the carb can go bad. I even had one that I caused myself by not putting the little spring (part #20 on the exploded view of the carb) that sits under the throttle motor in correctly.

Jul 10, 2012 | Honda EU3000iS Inverter Generator

1 Answer

What is the brown wire and blue wire for the power cord on roadpro100w


I would guess the blue is POSITIVE, and goes to the tip of the lighter plug. However, get a voltmeter and check...
Cheers.

Dec 21, 2017 | RoadPro Road Pro AC / DC Power Inverter...

1 Answer

I have a auto pro 800 watt inverter that gives 220volt ac **** wont run my kellerman freezer it runs in the house on ac can you help


If your freezer need more than 800 watts to run then your 800 watt inverter will be overloaded and it will shutdown.

Mar 21, 2012 | Vector 1000w Power Inverter

1 Answer

Why would my new 1500 watt inverter readout show overload 13.8 volts entering


It would show overload if you're drawing more power than it can supply. 1500 Watts is a very high output for an inverter but that is the maximum it's capable of. As with any electrical supply you should not draw the maximum power it's capable of as this can cause it to burn out. Around 1200 would be the max you should draw continuously. You need to check the power requirements of whatever you're running on it. Also you need to check that it's capable of taking 13.8 volts. If 12 volts is the recommended input, putting in 13.8 will increase the voltage output which could damage appliances being run on it.

Jan 10, 2011 | PowerBright New 1500 Watt 12V DC to AC...

1 Answer

When installing a power inverinto a truck should the ground go to the battery or to the chassis


Assuming truck is neg chassis/ground

Neg of inverter to neg of batt
Pos of inverter to pos of batt

Hope this helps
Thanks for using FixYa


Jul 04, 2010 | Vector VEC056D 2500 Watt Power Inverter...

2 Answers

2000 watt cobra inverter keeps saing olp, overload


2000w means is out off rang load 2000w plus then alarm beep have running.

Mar 24, 2009 | Cobra CPI 1000 DC to AC Power Inverter

Not finding what you are looking for?
Inverter 1000-2000w Peak Surge Power Logo

197 people viewed this question

Ask a Question

Usually answered in minutes!

Top Inverter Electronics - Others Experts

ray gallant

Level 3 Expert

70797 Answers

Tom Chichester

Level 3 Expert

60223 Answers

Anon

Level 3 Expert

1497 Answers

Are you an Inverter Electronics - Other Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...