Need help...my range JS968 cooktop seems to not cool down when turned down, even boils food when turned down to low, what can be done...I'm almost ready to purchase nother range. Thanks

If you're sure the engine is running cool enough check the fuel pressure, low fuel pressure can vapor lock if the engine is hot enough the gas will boil. The boiling point of 87 octane is 181 degrees Fahrenheit although gas is constantly being returned to the tank in order to cool the fuel rail low pressure will not return enough leaving room in the rail for gas to boil. Ignition coils are also known to break down when hot. I hope this helps. Take care.

I see if I can find a diagram, ensure you posted right model number here.

I would check the gas pressure at the meter reg .It sounds like you are saying too much gas to burners

Hello Sara,

I think you have a gasoven too?
in that case I think it is the flame safety device.
when that is gone, the burner goes on very low, although it looks like all went well.
It looks like the one I send you in the link, it is on the side of the oven burner.

I hpe this helps you, kind regards, Dik
Electrolux Tricity Bendix Oven Safety Device HG Fsd Solenoid 359070604...

Go to LG gas stove.com to find repair manual. Here is the link http://www.lg.com/us/support/parts-accessories

Visit this link to download the General Electric JS968 Range.

or check additional models in this link: geappliances.com/DocSearch/Dispatcher

Hope this helps; remembere to rate this answer.

I am not sure of this Model but most of the Gas Rail Cocks ( Taps) when you remove the knob you will find either a small hole drilled into the spindle This would be the Low Burner (simmer Rate) Adjustment there would be a small screwdriver requiredto do this , if its not there ,then there is usually a small screw on the side of the tap under the Knob Hope this will help you

I would have someone come out. Perhaps a gas plumber first. Gas is not something you want to fool around with yourself.

i have the same problem.. jgd8130.. can i change out the burners or orfices..etc to make one or two of the burners for more btu's? [email protected]

The problem is the pot(s) is too far from the heat. Jenn-air needs to make a burner cover that is closer to the burner for boiling water...