Picture curves inward and i see at least 3 of everything

When shooting wide angle pictures (as you would be doing when shooting buildings) the sides of the pictures will curve inwards...the wider the angle, the more pronounced the curve will be. This is perfectly normal.

bad convesion IC

The curving is caused by bad digital convergencr chips (2) located on large signal board. They need replaced along with blown pico fuses and the convergence resistors. Chips are huge compared to a regular IC. 2" x 1.5" and they will be bolted on fairly large heatsinks. Cloudy picture is most likely the coolant needs replaced in the picture tubes. This needs to be done approximately every 5 years.

You will need to have the convergence IC'S replaced and realine the set again.
call around and get prices.

Linearity coil (there are several) shorted causing HV to increase and causing HVSD, no replacement parts available. Replace sweep module to fix.

Its Your Convergence Chips!. And Maybe a few Resisters!. Common Problem with this kind Of Set!.....

Depends on your geographical area...300-450

convergence bad have it rebuilt

This is a convergence problem.. possible deflection problem... you might need a tech to look at it...

ur problems is on the pincushion check for a capacitor that its bad on the pincusion section  good luck.