Question about Sony KDF-E60A20 60 in. LCD HDTV

1 Answer

Blinking power light

When I turn on my tv the green light comes on then begins to blink red intermittently. The picture remains black with no sound.

Posted by tara_090 on

  • thomasharwoo Sep 27, 2008

    Turn power on, light flashes green. All I here is crackling with a black screen. Then the power light flashes red and the lamp bulb comes on and flashes red. We heard a 'pop" before it happened. I don't understand if it is a lamp, why did audio go out as well.

×

Ad

1 Answer

Anonymous

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 4 Answers

Start by counting the red blinks. This will hopefully tell you what the problem is. Then check back with the number of blinks.

Posted on Oct 13, 2008

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a Sony KSDR60XBR1. Beginning today, when I hit the power button the power/standby light blinks green approx 50 times and then begins to blink red 5 times. The picture is black and there is no...


Sounds like your lamp has failed. May not be physically blown but the 5 blink code indicates either the lamp or ballast has failed. Normally its the lamp. Good Luck!

Nov 21, 2010 | Sony KDS-R60XBR1 60" Projection HDTV

1 Answer

Blinking Green Light on Mitsubishi DLP 52525


the circut that detects the bulb has been also failing in these sets
and the conversion chip that controls the picture , and the transformers are not putting out the full power they are supposed to.
this set will need to be tested to determine the exact cause or causes

Oct 18, 2008 | Mitsubishi WD-52525 52" Rear Projection...

1 Answer

Maganavox flat screen tv no pic, red light blink codes...


Those blinks are fault codes. To know more visit the site linked here. http://electronicshelponline.blogspot.com/

Mar 25, 2017 | Televison & Video

2 Answers

SONY KDF-E55A20 5 red blinking lights on power button


Hi,
Symptom shows Lamp is weak in result and causing restart of TV again and again. Your TV requires new lamp as per following part number...
A1085447A* LAMP BLOCK ASSY XL-2200U
It is available in Sony Accessories Store for $200 and replacement procedure is written in instruction manual of TV.

Always buy Sony original lamp for TV and avoid aftermarket / cheap lamp for TV safety.

May 18, 2009 | Sony KV-36FV26 TV

1 Answer

Tv turns on but no picture just a red blinking light stays on


Red light blinking means there's a problem in the TV....

What kind of tv is it?

Feb 10, 2009 | Televison & Video

1 Answer

No picture or sound mitsubishi 62525


Capacitor failure is the most likely scenario the FMT ans Signal PWB would cause the picture interference and the power pwb would cause the lamp light to turn red and give a 34 code when the device/ input and menu buttons are pressed in together and held for five seconds. That chassis has issues with every board in the chassis having failed capacitors you can get repair kits for the V26 chassis at the follwing link that come with instructions. Your model is the V26 chassis. Heres the link.
http://servicemanuals.vstore.ca/

Jan 25, 2009 | Mitsubishi WD-62525 62" Rear Projection...

1 Answer

Click click repeatedly faded then red blinking light


Go to the video menu and turn the color control to minimum. Determine if you have a black & white picture or is it green & white. If the picture is greenish, you have a problem in the screen circuit or possibly a bad picture tube. If the black & white is ok then I would suspect a problem in the chroma circuit such as a bad video jungle IC or a crystal. However, because your set had a red blinking issue prior to your existing condition I would lean towards the picture tube as the source or your troubles. You can try a simple test to determine if you have an intermittant short . Take the back off the set, and with the insulated end of your screw driver, very very lightly tap on the neck of the picture tube near the socket. If you see green flashes or hear loud snaps in conjunction with your taps or the green tint goes away, chances are the tube is the cause. If so, you might try installing an isolation transformer on the picture tube. Good luck

Nov 29, 2007 | Toshiba 36A61 36" TV

3 Answers

Sony KP-51HW40 No Picture, only sound


to thus problem its very simple .! try to resolder at the back of the picture tube board.

Nov 26, 2006 | Sony KP-53V75 53" Rear Projection...

Not finding what you are looking for?
Sony KDF-E60A20 60 in. LCD HDTV Logo

Related Topics:

418 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76360 Answers

Muntejaya Ginting
Muntejaya Ginting

Level 3 Expert

10422 Answers

Ekse

Level 3 Expert

13434 Answers

Are you a Sony Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...