Red lightstays on no power how to fix - Performance Teknique ICBM-774 Car Audio Amplifier

Probably the door ajar switch on the door lock is bad. don-ohio

check with fault reader code

P0161 Ford O2 Sensor Heater Circuit Bank 2 Sensor 2 Try this link for more details about this error code. Gopakumar Gopalan Google

Whenyou connect the power adapter into the laptop, does the power LED lightup? If not then - The battery adapter or the adapter's power lead or the laptop's powersocket could be faulty. Check power adapter's DCplug that connects into the laptop power socket with a multi-meter, the voltageshould be slightly higher than the voltage that is printed on the label on thebottom of the adapter. If the voltage is zero or way below the voltage that isprinted on the label then the power adapter is faulty and needs to be replaced. If the adapter is OK thenconnect it to the laptop and power it up, then look at the power/batterycharging LED light and wriggle the power plug in the laptop's power socket.If the power/battery LED light flashes and in a certain position this LED lightstays firm, then the power socket is either faulty or it has a dry solder jointwhere it is connected to the motherboard. This can be repaired but itrequires the laptop to be completely dismantled to get at this power socket andrepair. If you cannot DIY then I suggest you get a quote first.

it may warning light tells you there is a problem and even in an accident airbag may fail/or go off at any time have that checked soon.by a professional.

If your ps3 doesnt turn on at all and its just a red light. You need a new internal power supply. If the ps3 turns on for just a few seconds and beeps you need to reflow your cpu and gpu on the motherboard. You have yellow light of death.

You can post your model number is someone may can find a owners manual to look for the info or look in your manual to see how it says to reset the light after the filter is changed.

DO a powerflee

here are the steps

1) unplug all the cables from the printer including power cable.

2) press and hold the on/off button on the printer for 30 seconds (this will release all the static from the printer)

3) plug back the cables and then try

sounds like hard drive failure , but may be settings in cmos