Question about Dacor MCS130 Millennia Electric Single Oven

1 Answer

Switch problem? Thanks, Sweet Rascal. The only way to stop the constant clicking noise is to push the light switch and hold it in. This, plus the other symptoms, makes me think that there is a problem with the switch that controls the oven light. Can you tell me whether it is possible to replace the switch without replacing the entire control panel, and if so how I would find the part number? Is it difficult to do? Thanks.

Posted by ageprof on

  • ageprof Aug 15, 2008

    How can I find a schematic for the touchpad of a Dacor MCS-130 wall oven? I will need a schematic in order to replace the switch properly. I also want to confirm that the indicated part is correct, as the Parts place quoted me an entirely different part. Also, I want to see if it is simpler just to replace the entire Touchpad, and what the price differential would be.



1 Answer

dewan nafees ahmed

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has written 7 tips or uploaded 3 video tips

  • Master
  • 1,894 Answers

Click here sir

there select range/stove/oven

in that select switch

after doing that see for the 3rd part.

this is the light switch you need.

replacing it is not very tough. but it is not that easy also.

since you are going to work near circuit boards this must be done carefully. if any small mistake will cause more problems.
everything depends upon your expertise sir.

thank you

switch problem? - 63de766.gif

Posted on Aug 15, 2008


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Door locked wont self clean

Turn off breaker for minute or so if no contact repair man mcro switch bad or out of position. Did he try to pull door right after candle. The motor takes time to clear the hook from the latch. If so he probly bent some thing in the mech that latches the door or on the switch plate that holds the micro switch

Apr 25, 2017 | DCS (WOTD-227) Double Oven

1 Answer

I'm getting a constant beeping sound and a F1

The F1 error code means that the computer thinks a button on the touchpad is stuck. Sometimes this can be resolved by making sure the touchpad connector fits tight into the control board. The F1 code can be cleared by pushing CANCEL/OFF. If it returns the touchpad needs to be replaced

Aug 10, 2011 | Magic Chef 9112 Gas Double Oven

1 Answer

Door was opened at beginning of self cleaning sequence.. locking mech is still stuck

hold button for light down and hold it wile pushing put in clean and wait till it starts then push stop or cancel and wait til cleared dont let go of light switch till done.if don't work have someone hold down the switch wile you turn off the breaker for 2 min

Dec 24, 2009 | Frigidaire Ovens

1 Answer

We have a Belling oven that we can't turn on. The numbers in the display are flashing and we can't figure out how to reset this or to turn it on. There are six buttons from left to right, one labelled...

We solved this by pushing both the "start cooking" and "stop cooking" buttons at the same time (these are the ones showing a pan with steam coming out of it and a pan that says stop above it). While holding these down we used the plus and minus buttons to set the time. After doing this we were able to turn the oven on.

Oct 25, 2009 | Belling XOU482 Electric Double Oven

3 Answers

My DACOR + ECS 130 covection oven light relay keeps clicking.....

I have the same problem and sent an e-mail to DACOR. A James Carlos responded and advised that DACOR could not provide DYI info because of liability problems, pure BS in my opinion. I've had problems with a DACOR microwave (manuf. by Sharp), my DACOR wall oven Model ECS103 and my DACOR Raised Vent system and told Mr. Carlos so. I don't know how to fix the blinking oven light other than cutting power at the circuit breaker panel or removing the two light bulbs which other have advised but suspect a new front control panel is required. If you find a fix, please advise me at [email protected]. I think DACOR products are overpriced and junk.

Thanks, Bill 12/10/2009

Aug 27, 2009 | Dacor ECS130 Epicure Electric Single Oven

1 Answer

The bottom oven on my stoves cooker ignites but then constantly clicks and will not stop until the gas dial is switched off. Can any one give me a clue as to why? Thanks

As an ex stoves enginneer, the problem may be one of three faults;
1. cracked electrode, what creats the spark in the oven
2.electrode lead has melted.
3. faulty ignition generator.
Try takin the lead off the electrode and placing it in the oven flame, if this stops the clicking, then replace the electrode.

Jun 10, 2009 | Stoves Ovens

1 Answer

Hi, I have an oven ''Stove 605 MF'' and we had a power cut but for some reasons when the power came back the oven lights started blinking constantly and we are unable to use the oven since then??? I tried...

Try holding the cancel/off button for 10 seconds.
If that does not correct the problem you probably have a bad clock control from the power surge when power was restored.

Mar 20, 2009 | Stoves Ovens

2 Answers

Wolf oven - oven clicks continuously

This sounds like you have a flame switch getting ready to go out. The reason you are hearing the ticking noise is that after the ignition is satisfied the flame switch is not detecting and sending a signal to continue to try for ignition.

Nov 02, 2008 | Ovens

2 Answers

Dacor oven light

Open the over door. Remove the four screws holding in the digital display. Pull it off (have something to stand it up on). Look for the small ribbon going between the printed circuit board (PCB) and the digital display you just removed. Pull the ribbon out from the connector on the PCB. On my model, ECS127SBK, push the three right pins down, and re-connect with just the two left pins. Other models, may be different, so you may have to test it out. Be sure to turn off the power at your breaker box while working on it. You won't have the use of the lightbulbs anymore, but you won't have the damn ticking either! (And you'll save yourself getting ripped off from a technician.) I'm not very skilled when it comes to this stuff, so if I can do it, you can too!

Sep 23, 2008 | Dacor MCS130 Millennia Electric Single...

15 Answers

Oven Lock stuck open before start of self-cleaning cycle

push in on the oven light switch and hit clean then cancel you have to hold the oven light switch thats what tells the eoc the door is closed if this dont work reply to me

Jun 05, 2008 | Frigidaire 30" Self-Cleaning Freestanding...

Not finding what you are looking for?
Dacor MCS130 Millennia Electric Single Oven Logo

279 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dacor Ovens Experts

Tyler T

Level 1 Expert

35 Answers

Paul Bade

Level 3 Expert

1662 Answers

Lollo Pop

Level 2 Expert

134 Answers

Are you a Dacor Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides