Kx-t77730 when i install panasonic kx-ta308 and use panasonic kx-t7730, the kx-t7730 theirs no ring but its functioning...

OK -here is a link to the users manual. Section 4 is system programming. Page 4-9 In section 4.2 has the instructions to set the Time and Day. http://www.voicesonic.com/panasonic/manuals/KX-TA308-616_System/KX-TA308_InstalationManual.pdf http://www.voicesonic.com/panasonic/manuals/KX-TA308-616_System/KX-TA308_InstalationManual.pdf

There are two possibilities, you have to check to confirm. Either the two were physically wired in parallel or through programming they were configured to ring simultaneously. Start by checking if the two were physically wired in parallel. One way would be to establish how many extensions you have altogether and is it equal or less than the total number of extension ports available on the KX-TA308?

You don't. Panasonic analog system phones have one ring tone. You can change the cadence (single double or triple) ring from outside calls, but not the tone.

Carl

you have to do that in the pabx setting where by you set all out going calls to be calling direct but all incoming calls to be calling to the switchboard first so change the call restriction feature

On the phone press PROGRAM, press the original DAY button, dial the number 2, dial 781#, press AUTO DIAL STORE, pick up and drop the handpiece.

Hello, from the Switcboard / Main telephone ( usually ext 101, 10 or 9 ) with the handset on the cradle press Program * # followed by the system password ( default is 1234). Now press 001 and then SP-PHONE. Enter the system speeddial location ( 00 to 99 ) or just press SP-PHONE again to go to 00. Now enter your line access number ( usually 0 or 9 ) followed by the telephone number you would like to assign for the speeddial. Now press AUTO DIAL / STORE to save your setting. To go to the next speeddial location press SP-PHONE and follow the above steps again. Press Program to exit program mode. To dial the system speeddial from any extesion lift the handset and press * followed by the speeddial location ( example 00 )
PLEASE rate this answer if it was helpful.
Thank you.

press program button then press the flexible where you want program the CO line then press 0, here u can select which CO line need to be program.

Ali

walk up to the phone and without touching anything else, press "1".

No music.

Carl

try 408

i have 10 extentions but my call ring to all extentions. but the ring to one extentions 101 only plz tell me