Question about Dishwashers

1 Answer

Wiring diagram on door latch for Frigidaire dish washer model number fdp635rfr3

Posted by rogerlee566 on


1 Answer


  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert who has answered 20 questions.


    An expert that has over 10 points.


    An expert whose answer got voted for 2 times.

  • Expert
  • 88 Answers


you will get on this web side all manual digram parts no

Posted on Aug 15, 2008


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My affinity washer door wont close. Seems the door lock is not working or something is stopping the door from latching

you may have broken off a piece of the latch
(hook portion) either on the door or the receiver portion on the machine. check for diagrams online using model #

I’m happy to assist further over the phone at

Apr 04, 2016 | Frigidaire Affinity FAFW3577KW 3.5 Cu. Ft....

1 Answer

I am working on a Frigidaire washer model LAFW3511KWO custmer say it stopped when she trys to start it door latch just hums? Bad board.or latch?

Thank you for your inquiry, Larry!
From the information you have provided your Frigidaire washer is humming when you attempt to start a cycle. This could be a possible issue with door latch or control board. Does the washer display any error codes? I would recommend checking for any damages or cracks along the door strike or door latch that could cause the washer to not show a connection between the two. If there is no damage, you would need to disassemble your washer and test out the control panel and door latch. I hope this information is helpful to you. -Matt

Aug 31, 2015 | Frigidaire Washing Machines

1 Answer

I have a Frigidaire Front Load washer Model#ATF6000FS2 washer . It will not start and seems to be experiencing a problem with the door. There is 'DOOR LOCK' light that does not turn on and th

Sounds like the door is not latching correctly. Check the door for any sagging problems and then check the door latch itself for any damages, cracks, or issues with the door itself connecting to it.

Jul 21, 2012 | Frigidaire ATF6000ES Front Load Washer

3 Answers

GE WSSH300G Front Load Washer drains, but won't spin. Repairman wanted $340 to replace a door latch. ???

Door latch for that model I chrge labor and materials minmum charge is 180 ... its easy to replace ..2 minutes done...

May 25, 2011 | General Electric WSSH300G Front Load...

1 Answer

Soap door wont open

I have replaced a dish washer soap dispenser once. Not hard to do. Need the make and model number. This dispenser is activated mechanically so there may be a broken latch or spring in the dispenser. Check the dispensers operation manually and see if it appears to be operating normally.

Jan 16, 2010 | Frigidaire FDBB1940D Dishwasher

1 Answer

The door hinge has been broken and have been having to lift up to close door, but the latch has finally broken and door will not shut now. whre can i get a new one?

My recommendation: 1-800-FRIGIDA(like Frigidaire), have your model number ready,it can be found on the washer door opening(washer side). Good luck !

Dec 20, 2009 | Frigidaire Affinity ATF7000EG

1 Answer

The lid will not lock, therefore the washer will not drain or spin


Replace the door lock.

If the door lock is not at fault, then replace wiring harness between door latch and control board.

Enter model number here to find parts and diagrams.

Nov 14, 2009 | Whirlpool Cabrio WTW6600SBT Top Load...

2 Answers

Dish washer that does not pump out the water on it"s final cycle

I had this same problem and after having the repairman over to our house several times and having the circuit board changed, I figured it out on my own...

It turns out that the pressure created from the steam during the water heating stage (HO) was pushing on the door latch just enough to prevent the motor from running properly. Because the door wasn't latched completely, the water wouldn't drain and the dishwasher would go to the "Drying" cycle without ever pumping the water out of the basin.

I adjusted the levelling on the DW and that helped, but I'm still not sure that the problem is fixed. We may need a new latch assembly.

To test this, when the DW stops running at any time, push on the door. If the motor kicks back on, this is the problem.

Dec 27, 2008 | Frigidaire 24 in. FDB635RF Built-in...

Not finding what you are looking for?
Dishwashers Logo

Related Topics:

354 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dishwashers Experts


Level 3 Expert

85239 Answers

Brad Brown

Level 3 Expert

18342 Answers

Cindy Wells

Level 3 Expert

6102 Answers

Are you a Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides