Please run setup invalid configuration information

Remove power and the battery. Replace the power lead and boot normally. Check all is OK power down, add the battery and re boot.
Don't use sleep mode it can cause untold issues.

have you tried these..F1
F2
F10
DEL
ESC

When you removed the battery your computer lost all of it's configuration settings. You have to go into the set-up menu and and select the devices that are installed on your computer. Such as floppy drive, CD drive, DVD drive. Also have to set date and time.

Means reinstall windows or recovery

Start your computer and after the BIOS screen disappers , begin rapidly pressing PF8 until the Windows Boot Options appear. You should see "Safe Mode", "Boot from last valid configuration", and "Normal Mode", and maybe a few others. Select "Last Valid Configuration." Computer should sucessfully boot.

Soon As It Starts Press F8 F8 F8 F8 F8 That Should Get You In

Try removing both memory sticks and then booting up with just one installed. The bios should notice a shift in the amount of memory and prompt you to enter the bios.

Let me know if that works.

STEPS
1)"F2" on Dell Logo to go to bios screen

load Bios defaults in bios

Save and exit from bios

2)Install BIOS Update from support.dell.com

If the battery is changed, that will mean that the BIOS was set back to january 1 1980.
Go into BIOS, set the clock to the correct time.

For DELL 370 precision , here is the BIOS instruction:

http://support.dell.com/support/edocs/systems/ws370/


Replacing the Battery CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide. NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface on the computer.
A coin-cell battery maintains computer configuration, date, and time information. The battery can last several years.
The battery may need replacing if you have repeatedly reset the time and date information after turning on the computer or if one of the following messages appear:
Time-of-day not set - please run SETUP program
or
Invalid configuration information -
please run SETUP program
or
Strike the F1 key to continue,
F2 to run the setup utility
To determine whether you need to replace the battery, reenter the time and date in system setup and exit the program to save the information. Turn off your computer and disconnect it from the electrical outlet for a few hours; then reconnect the computer, turn it on, and enter system setup. If the date and time are not correct in system setup, replace the battery.
You can operate your computer without a battery; however, without a battery, the configuration information is erased if the computer is turned off or unplugged from the electrical outlet. In this case, you must enter system setup and reset the configuration options.

Windows Registry help First, get the computer to a MS-DOS prompt. Information about how to get to a ... that contains information about the current configuration of hardware ...


FTP information and help
Information about FTP and its commands. ... If you are unable to connect to any address, it is likely an issue with the network or computer configuration. ...


Device Manager information and help See our overview section for additional information on how you can get into ..... but the configuration information in the .inf file is set to hardwired. ...


Good Luck, Please dont for get to Vote.Thank you