- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The tv PCB board manual contol buttons board is shorted,that why u have ramdoom screen menu pop up.Tries websites like Shopjimmy.com,Ebay.com to buy a refurbish Tv manual PCB control board for the replacement.
The best thing to do wuld be to first, back up all of the stuff on your ipod, and the restore it back to factory setting through itunes. After that, you can put all of your files back on the ipod and it should function normally.
I have found that my aiptek digital camcorder also freezes like this sometimes after I have pressed the button to stop recording a movie. You are right that sometimes you must remove the battery to unfreeze it, but I have found a couple of other tricks that work sometimes.
1. You can hold down the menu button for a few seconds (like 6). Sometimes this kicks it into the menu and unfreezes it.
2. Sometimes using the power button inside of where the screen stores to turn it on and then off again often helps.
3. Popping the digital card out (push in so it unlocks, then push it right back in) also helps unfreeze it for me.
If those don't work, pop the battery out again.
I do find that every few months I need to clean the connection points on both my battery and the camera where the battery clicks in. After I do this it behaves much better for a couple months. Good luck.
Sounds like the sensitivity is whacked...can you hear the type sound. Mine does this sometimes and I solve it by using 2 thumbs and constantly push the settings icon, on each side. It will bring up the x for sensitivity...using the stylus tap gently and then twice to set. Hope this is what you were looking for.
My Centro doesn't respond
("freeze") on incoming calls up to 10 times a day. The
"answer" button (on the screen) and green "send" button
(next to "phone") block and it is impossible to accept the incoming
calls. It is necessary to perform a soft reset to solve the problem temporary.
Even after hard reset the situation is the same. This is very
frustrating for a new device. Sometimes, frequent callibration of the screen
from the "Preferences" menue delays the freezing effect. AFAIK the
problem is software-related, considering the recovery after reset. Is there any update on the palm
support page / forums,
related to the problem? I couldn't find any. From time to time, there is
onother problem I experienced - from the contact menu it is difficult to dial the selected number. Sometimes it is
necessary to press“dial”several times
resulting in significant delay.