HP Laser Jet 4L jammed at rear.Cannot release paper

HP color Laser Jet 2600 printer has a paper jam

Clear the paper jam...
Also make sure all the pick up rollers are not smooth, if they are replace them. Also make sure the tray is set to the right paper and not offset. A lot of times people slam the tray and it moves the setting bar.

remove cartriage from printer then pull paper inside or out side from printer

The pickup roller most likely needs to cleaned. Normally paper dust causes this condition. Put the printer off and try again. If you still have the same problem then you probably have paper stuck in the printer somewhere, the paper sensor under the printer is broken. This is quite an old printer and spares might be a problem.


Good Luck

There is either a small piece of paper in your paper input section or you have a paper sensor going bad.

HI ayyasamyr:
This your problem.
13.10 PAPER JAM The event log message for a paper-delay jam in the duplexer is 13.10.
1. Check the duplexer and the rear area of the printer for obstructions or damage.
2. Check PS1701 and PS1703 in the duplexer for correct operation. Replace the
duplexer if a sensor is defective.

Hope this helps

document feeder jam

it sounds like the pickup roller is bad & needs to be replaced

You have a broken gear main motor. I had the same problem, bought $5 part and after the replacement of the gear,it runs like new

Try lowering the toner density using the printing software or the printer menu.