I just got a new Diesel Audio NS-9915, I dont have manuel so I can not set clock or adjust sound I need help! Please

Make sure that the audio cables are properly connected for the source (component, composite video or VGA/DVI (computer or other device)). Disconnect any cable in the headphone port.

Was the TV ever used with an audio receiver? If so, the TV speakers may have been turned off. Go to the Home Menu. Go to Settings > Display and Audio > Audio Output > TV Speakers and set this to On. (For Quick settings, press and hold Home. Then go to Sound > TV Speakers and set to On.) If you have a universal remote, the remote could be set to give all audio commands to a receiver. Try the remote so the Audio commands go to the TV. (This will depend on the remote. Please add a comment with the remote brand, model and type (often inside the battery compartment) for the full programming information.)

If you are using external speakers with a receiver, you may need to change the audio settings to PCM for a digital audio output. (This is in the same Audio Output section of the standard menu.)

I hope this helps.

Cindy Wells
(I've locked several remotes to the audio system which causes this type of problem when the home theater system needs a wiring repair.)

hi if you click on this link it will bring up the instruction manual for your model. as well as the 238.
setting the clock is on page 10
hope i have helped, please dont forget to rate.

if you are trying to use it with the stock headunit you would need to buy a line output converter to use your amp and sub. after you buy the converter you will then need to splice into one of your rear speaker wires so you can run the rca's to the amp and continue with normal install

try hotting your remote wire to your batter if it don't come on u will need a new amp

does your new sub have a volume or gain control? If your getting the signal source from the line outs, then the volume level there is constant. You need to set it up so that it can be controlled by the main volume control.Or you might need a control pre-amplifier before your sub

For most Pioneer single CD players, you can set the clock using the following steps:

1. Press and hold the SOURCE button until the unit shuts off.
2. Press and hold SOURCE again until the clock appears. With some models you will press and hold the FUNCTION or AUDIO button instead of the SOURCE button.
3. Press the left or right arrow to select the segment of time you wish to adjust.
4. Press the up or down arrows to increase or decrease the numbers in the blinking segment.
5. Once the clock is set correctly, press the SOURCE button to exit.

Hold down the t/f button until time blinks. Use the volume to set. Up for hour, down for minutes.

aplications/driver/audio/set up exe

Amazon. com has the manual:
http://www.amazon.com/BellSouth-MH9915BK-900MHz-Cordless-Phone/dp/B00005U23W

it can be done providing it isn't driven too hard.