I try to connect with the usb n the usb keeps blinking so tht means the transmitter is now working properly????

plug the transmitter into a usb port. make sure batteries are in the mouse and the switch is on. press the button on the transmitter and the red light will blink slowly. next, press the reset button on the bottom of the mouse. when the red light on the transmitter blinks fast, it has connected.

Your connection between the AR transmitter and the ONKYO receiver sounds solid. I'd guess it's the wireless speakers that are the wrong point, or at least that's what I'd look at first. Doing a bit of research, I noticed a couple minor points. First, these seem prone to RF interference from other RF devices. Have to tried switching channels on them? Second, someone reported theirs would not work properly unless the speakers were turned on just before the transmitter, and turned off shortly after the transmitter. Apparently you have to hold the button on the front in for 5 seconds to turn the speakers on or off. I know that's rather basic, but it's been a few days and no one else has responded, so I figured we should start somewhere.

Hi there.
Some wireless mice seem to go into some kind of sleep mode, in other words if you leave them for an amount of time they disconnect, the way to reconnect is to right click while moving the mouse.
Also check to make sure that the batteries in the mouse are seated properly.


Good luck

This is sort of general but it just may help.
Make sure your batteries are in correctly.
Make sure the transmitter dongle is in the USB.
Look on the transmitter and the mouse and keyboard
itself (bottom) for a little tiny button that says connect
or reconnect. Move the mouse about six inches away from
the transmitter and press both the transmitter and the mouse.
That should reestablish the signal twixt the two.(or three KB)

Change yor keyboard. If any one key remains pressd or if any pin is bent then evrything seems to work but there is no Display and no beeps or error messages either!......i too suffered the same once................sodeep

I just came home to find this same problem. Four blinking lights on the wireless controller and the inability to sync the controller with my 360. On a whim I took out my controller's battery and then reinserted it after a few seconds. Voila! Problem solved. Controller works normally again!

pls be a little more elaborate next timeas to ur connection type do u have dsl or cable or dial up and stuff like tht
assuming u have dsl cable or high speed and not dial up or tht is ur dial up is working properly and no probs with tht
then we can go on
go to internet options in the tools menu i belive then go to connection then make sure u have no proxies on if u dont own a proxy
what is a proxy? if u asked tht question then u 99$ dont ahve a proxy which is good
now click automatically detect settings and thts it for this part
if tht doesnt fix ur prob
then
make sure ur dsl connection is properly working and tht its not disabled in my network places

wat is the error msg tht u get?? Did tht pen drive came with a cd......try connecting the pendrive to all usb ports on the system....if tht doesnt wrk, go to device manager & then uninstall all usb root hub under usb option.....restart system thn chk

is tht a plug & play or did it come with a software cd......try connecting it to different usb ports on the system......if tht doesnt wrk, try onnecting the usb device to a different system to chk functionality of the device