ALL I NEED IS A ******* PIC SO THAT I CAN SET THE FKN SWITCHES

Some people just do the bolts up FT and use thread locker with a texta mark to watch and see if they're coming undone. If your using new bolts there should be a reccomended torque tension, but if your using the ones that came off just do them fkn tight with thread locker.

Try this link to download a factory manual in PDF format
Mazda B3 engine service manual

if you can post a pic of the connectors and and the switches - I can give you some guidance.

Is the battery fully charged ?

Hi, in other to send a picture message, you will need to activate mms service on your phone.

mms network service allows you to be able to send picture message through multimedia message.

To be able to do this, you will need to contact your service provider (customers service center).

Take care.

They are the only one who

actually your driver is conflict please remove current driver and re-install original driver.

You will need a reset within the deep switch setting
1) Push the left button on the front panel
2) Navigate to "service"
3) push immediately on tv set from your hand control

A new screen will give you access to all deep switches settings.
Be careful, not all settings must be modified, there is a risk of "instant Killing"
You can find the basic setting recommendations on the Web for your TV set

put the fkn phone in the microwave and leave it on 100, and after u hear a huge bang it should be formatted.

Check and see how much memory you have installed in your computer. It take additional memory to operate the camera. It could be another problem if you have enough memory.
Hope this helps. Bud

chuck it in da fkn bin