I have a belkin router asdl wireless how to secure the connection

if you want to remove security key, just reset the router by pressing the hole or reset button and then type in brower 192.168.1.1 and access in your router.then you can assign new security if you want or leave without security. just connect your computer by hard wire and by same wire other end of this wire will connect to router. don't need to do anythig. computer n router knows best everything else what to do.

Is there any computer connected to the router ?
If not then you will need to connect the computer to the router.
Do not change any wireless settings on the router with the wireless computer.
you will need to connect the computer to the router with the Ethernet cable.
check the IP address of the computer.
open the router set up page of the router.
Here you can change the wireless settings of the router.
Now once you change the network anme and security on the router, you will need to connect to the wireless network on your wireless computers.
Click Here for step by step instructions

You want to secure the wireless network.
Is there any computer connected to the router with the Ethernet cable?
If not then you will need to connect the computer to the router with the cable.
Check the IP address on the computer. Open the router set up page.
Once you open the set up page, you will find the option to make it secured

Click Here for step by step instructions

u can acess router with following link
http://192.168.0.1
or http://192.168.1.1

type username and password "admin"
or password remain blank
.

The wireless security on your router might be enabled.

1. In the address bar of your Internet browser, type "192.168.2.1". Then press the "Enter" key.

2. It will prompt for a password to access the Router’s Web-Based Advanced User Interface. By default the password is blank.

3. Go to Security, then Wireless.
- Check the wireless security settings, this should match the settings on your wireless computer.

4. On the wireless computer, you should detect SSID and if wireless security is enabled, connect to it with the correct security keys.

Hope this helps! Good luck!

access your router with following link

http://192.168.0.1

then type user name:admin
password is:admin or blank

then enable DHCP.then u can get ip automatically.

1. you need to put the software belkin installation disc into the girls laptop not just the desktop.

2. you need to plug the modem back in

3. on the back of the router press the little button NOT THE RESET BUTTON MAKE SURE IT IS THE LOCK BUTTON it will ask you for a password on the laptop

You can directly connect your computer to the router thorugh the routers "internet" port and then re-run setup. OR you can type the IP address of the router into your address bar (the default is tipically 192.168.1.1 or 192.168.0.1) and then enter the router username and password (I believe the Belkin default is username:"Admin" password:"Password") in the admin control planel look for a "wireless security" tab. You can then define your wirelss security settings there. Just remember to configre the same settings on all devices that will connect to the router.

You're wanting to connect the directly connect the DI-514 to the ASDL modem to give you a wireless network, right? If so here's what you do:
Connect an ethernet line from the modem to the Internet/Wan port of your DI-514 and then you're set. I recommend you then follow the directions in the manual to setup wireless security.

If you're wanting to have your DI-514 wirelessly connect to the ASDL modem, then connect your PC to one of the LAN ports of the DI-514 and open the administrative web interface (usually located at http://192.168.0.1) and go to the wireless section and select "Wireless Client" and input the MAC of the ASDL modem's wireless interface (you can find this on the administration web interface of the ASDL modem) and you should be good to go.