Question about Adaptec Computers & Internet

Open Question

Adaptec 3405 making continuous noise RAID5 is configured on this. Observation :- This thing was observer first 4 days back when there was a power cut(I got UPS in place for power backup). Then i removed the card from its slot and re-installed in to the same slot and run ADAPTEC raid utility by Ctrl+a, the noice was gone. Again today it is making same kind of continuous noice, but this time there was no power issue. Please help me to solve this issue.

Posted by srini_s_vas on


1 Related Answer

Muzahura Frank

  • 2069 Answers

SOURCE: I have successfully installed a

two things i would suggest in this case. 1- check that you have the latest bios for your card here. 2- check here for the latest drivers here and the compatibility list here.

Posted on Jun 17, 2011


Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Maytag neptune dryer makes loud noise on the right side when top dryer is on

The belt tensioner bushing could be shot or there may be a piece missing from the belt. Did you check the back for a removable observation cover?

Jan 05, 2014 | Maytag Neptune MCE8000AY Electric Dryer

1 Answer

Making too much noises.

The compressor fittings may be loose and the mounting could have gone SOFT thereby making more vibration that radiates to the body and the plastic sections to make a larger noise.
You need to move the fridge forward and check the mountings of the compressor, the grills , the coils and the body . Switch on and observe the noise as the compressor runs and it will be possible to confirm with a good observation - use a good lamp to check for loose ends.

Aug 19, 2011 | Hotpoint FFA60 Bottom Freezer Refrigerator

2 Answers

What is guided observation?


It is an observation exercise where the observer has to follow specific parameters and to perform specific tasks, usually detailed in a written form or checklist.

If for example you do a guided observation of a teaching session you may be asked to base your evaluation of the lecturer on parameter such as:

Lecture structure.
Use of multimedia materials.
Time dedicated to pupil's questions.
Interactive activities.
Use of resources.
Technical knowledge.

The list of parameters written above will be the guide for the lecture's observation.



Jul 20, 2011 | Watches

1 Answer

Noise in operation. A loud rumbling noise when

Any noise must be identified with a good observation of the point of noise source.
This can be done with a good view with all safety precaution while the unit moves. Use good lighting and make sure that you are not putting your hands into any moving parts while the set works.
Now disconnect after observation and manually turn the drum, the motor and the rotor to fix the point of noise. this can be a faulty bearing assembly or a faulty suspension all of which will require a resetting/reassembly.

Feb 17, 2011 | Whirlpool LER4634J Electric Dryer

1 Answer

The engine is making a noise, what do i do?

It all depends on the noise, the observation of the noise if coming from the outside or from within the engine.
Check your belts, fan, water pump bearings, pulley etc as the noise from the outside.
If this is inside noise you need to take opinion and estimate.

Jan 31, 2011 | 2000 Kia Sportage

1 Answer

Not cooling

Turn your System OFF and put the Fan switch at your thermostat in the FAN or ON position. Allow it to run like this for 4 hours minimum. Before turning the system back on, ensure the air filter(s) and coils are clean. Also make sure all of the supply registers are open. All of these items affect airflow. Improper airflow is the number one cause of an iced up evaporator coil (as indicated by your observation of ice on the black hose). If, after doing all these things, you continue to have a problem, you most likely have a refrigerant problem (not enough or a restriction). This would require paying a CFC certified electrician to diagnose and repair. Try the air filters, coils, and registers first. :-)

May 29, 2010 | Ruud Central System Air Conditioner

1 Answer

Car Shuts off after driving

either needs a new ignition relay or the wireing harness was not properly reconnected when the transmition was installed

Aug 14, 2009 | 2000 Chrysler Sebring

1 Answer

Manual kawasaki zzr400

My kawasaki has the same noise, specially when cold, but this should go off when your bike temp goes 1/4.thats my observation with my ZZR400

Feb 25, 2009 | 1997 kawasaki ZZR 400

Not finding what you are looking for?
Computers & Internet Logo

Related Topics:

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Adaptec Computers & Internet Experts

John Dio

Level 1 Expert

10 Answers

Robert Graf

Level 2 Expert

268 Answers


Level 3 Expert

1997 Answers

Are you an Adaptec Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides