I bought a Scott 76121 mini speader but lost the instruction. Where can I go online to get them

3.5 to 4

Either send a message via
https://www.scotts.com/smg/templates/index.jsp?pageId=24900010&nodeId=7800006&
asking if they can supply a spare or
Go to the store, look at a new one and measure the spring. then buy one the same from a hardware store.

Usual to find this info on the fertilizer itself. It will show which number to set the spreader at.

You can use the recommended settings for the SpeedyGreen 1000!

Hilary @Scotts

Most major manufacturers supply manuals online so if you were to log on to the manufacturer's web site, you may be pleasantly surprised as usually, if available, one is able to download, by model number, Customer Instruction Manuals, Dealer Network for spare part supplies as required.

The information is normally free of charge.

I hope this helps.

Before you throw any more money at this problem, have you considered that the problem might be with the Infra-red (IR) receiver in the TV?

Also, did you programme the correct codes for your Scott TV into the universal remote/s? If you can let me know the model number/s of the universal remote/s - and you still have them - I can probably verify the codes and the programming instructions.

Hope this helps.

Jeremy the settings to use, are usually listed on the bag of fertilizer.
Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."

http://www.agri-fab.com/utilities/support/manuals.aspx

Agri Fab Model List and Online Parts Diagram

What do you need help with? Well, you can go on the instructions online. The address is: apple.com.
Here you can chat with ipod experts, look up your ipod mini, or even register it.

it sounds like a needle threading problem. if you have the instruction book, pull yout needle thread off the machine and re-thread as per the book ie presser foot up and make sure thread goes betwen tension discs and up over takeup lever.

to check needle tension is ok, lower presser foot and pull needle thread through needle, the needle thread should be tight enough to bend the needle a little.

goodluck,

scott.

Scott's evergreen drop speader, calibration. Set dial to 6 and adjust tension until the teeth line up with the calibration mark, Alternatively ring Scotts and get full instructions They are very helpful.