I have purchased a 2004 Sivercrest Manufactured Home. The water heater is an Intertherm Model IN140NHMT2 Serial HO4133796. The water temperature seems to be very hot. I have changed the temperature control knob from the setting of B down to HOT. It has not made that big of a difference. Is on od the other settings a lower temperature? The Temperature Control Knob has the settings of VERY HOT/C/B/A/HOT.

SOURCE: unable to change the blower

the air will not blow through windscreen vents but is blowing through every where else. makes no difference when changing the direction of the knob to the windscreen only. you can hear the air blowing but nothing comes through?

Greg Bernett

• 2993 Answers
• Posted on Mar 13, 2009

SOURCE: TEMPERATURE CONTROL KNOB WILL NOT WORK ON WARM OR HOT

If you can pull the rotating knob off, use a pair of pliers and rotate the rod and see if it works....or, does the knob seem like it is not grabbing?

SOURCE: Thermo King Super II SR BM#092170 will not lower its temperature

try to clean gas cooler (it is radiator outside),unplug it from power (wall) then clean it with brush up-down (not left-right),wait 1hour and turn on

SOURCE: Rheem Gas Hot water Heater; Model 21130DV:

yes, sounds like the temp control is bad, you should be able to google model# and thermostat to find replacement. should be fairly easy to swap out

Paul

• 144 Answers
• Posted on Mar 30, 2010

SOURCE: Temperature lowering problem.................

Are you referring to 16 degrees and 34 degrees?
If you are, it is not possible to lower the setting to 16 degrees, 32 degreees is freezing, so the evaperator coil would start to freeze up, and as the ice spreads across the coil............... Air can not flow through ice, so the air will stop blowing, till you shut the system down for a couple of hours, to allow the ice to melt.
This is the reason why these units are set with min. temp settings.
I hope this helps.
Sincerely,
Paul Gibson