Check waste toner box error on kyocera fs-2000d

the top of the waste toner container must be cleaned 100% from the toner because it should be a light sensor that has to pass through it , if its spoiled with toner the light cannot pass through it ,so i recommend you to empty the waste toner container first and wash it with water and drying it well before using it again.

You need to replace the waste toner box.
http://www.kyoceramita.co.uk/index/products/consumable/toner_installation.-cps-12303-files-97992-File.cpsdownload.tmp/Toner-2000D.pdf

7410 is an error (all numbers following : is the number of pages printed.

- indicating the Drum Unit is not installed properly or you have a defective curcit board. Tyoically it is drum drum is not fully seated.

If you open the door on the left hand side of the printer, where your waste toner container goes and press firmaly on the drum which is loacted behind the waste toner container and close the printer backup. If the drum is properly seated the error should close.

I hope this is helpful,
Shawn

Check your waste toner box. At the side of the printer is a container for the extra toner to be stored. Everytime you change your cartridge you need to change the waste toner container. Carefully open side panel and remove waste toner bottle. There is a button you need to push do not force the bottle out.
Remove lid of new waste toner bottle and put into place and close side panel. Follow link for further details or use your setup guide that came with the printer on how to install the waste toner bottle.
http://usa.kyoceramita.com/americas/jsp/upload/resource/15865/0/2000D-3900D-4000DMLIIR1.1.pdf

most likely the drum popped out.
open the left side cover and remove the waste toner bottle..seated just above the waste toner bottle..press on the drum unit that sits above it..you will here it pop back into place .. if you hear it snap back it simply power off than back on printer....
if the drum is seated correctly.. than you need to replace the drum unit

open top cover then pull the developer unit (toner box ) then open left cover remove the waist toner box ..... there you can find a Grey color lock push and pull the full unit

for manual send mail to [email protected]

This code is because the printer believes that the drum is not installed.This usually happens when the waste toner container is changed,Open tje waste toner cartridge door and push into the printer all the components.You will find that the drum unit will push into the machine.Then close the door and turn the machine off at the wall.When you power back up the error code should have reset.

first turn off your pritner power.
check open the front door pull your ink cartridge then clean dust and blur from it then check there is not any paper jam then refix ink cartridge.then turn on the power.

open the left side door and push in the drum unit firmly. it's the part above the waste toner

Hi, Sound like drum unit is out off position.
Switch off printer.Open left side door, remove waste toner bottle and push drum unit(with grej lever on it) in printer to proper position.If grey lever is not in proper position, drum will be not locked.Place waste toner bottle in position.Switch on printer.