Burners and topplates are corroded on my 30" built-in grill. I don''t know the serial # of the grill or the parts. Can someone tell me?

You don't see brass burners much any more, because of the iron content. However, stainless steel replacement burners are available for your model. Check them out at the link below.

http://www.clagrills.com/grillparts/uniflame/uniflame-grill-parts-home.htm


I hope this helps you and Happy Grilling!!

Grills arre pretty simple ,the gas is attatched by a hose with a regulator with a valve to turn offf and on. Just follow the piping back from the burners and it should be there unless it isn't. Then you will ha e to buy one and the sizes vary so at times they are hard to match up and you probalbly need another burner as well ,hat is when you ask yourself how much do you really like this grill. It kinda souds like someone already salvaged it for parts and that is what is left. Goodluck let me know if you need any more asssistance

You might want to check to see if the ignitor is ground properly to the grill.

No, Mark, we at FixYa don't sell parts, or accessories. We simply provide information to questioners like you, on how to repair just about anything. And we also tell folks where to find the parts they're looking for.

In your case, the only place I have been able to find replacement parts for Cabana Kitchen grills. And even then, they want you to go through your local dealer (who you purchased it from) to order replacement parts. I suspect, the dealer may have the cooking grates and the Flame Tamers (the covers that go over the burners), in stock. If not, they should be readily available to them.

The other option is to measure your grill grates and flame tamers and search online for other manufacturer's who use the same dimensions or are very close. When you replace your grill grates, I highly recommend Stainless Steel and the same thing for the Flame Tamers. Yes, it cost a little bit more, but it's well worth it in the long run. I just did my own grill (which is very similar to Cabana Kitchens) that way. And I couldn't be happier.

Cabana Kitchens makes a great grill, but they're lousy about selling parts directly to the consumer. But, they're other companies that do the same thing (i.e. Vermont Castings, Rinnai, Dimplex, Traeger Grills, etc). Anyway, I hope I provided enough information to steer you in the right direction. Please let me know. Thanks.

You can purchase them on line at http://www.appliancepartspros.com
Make sure you have your Model # & Serial # of your grill. Or if you know the part number, so much the better.

Happy Grilling!!!

Hello,
If it was me, I would,first try to clean them and see if that improves the flames. During the course of cleaning you can determine if the burners are corroded and needing replacement or just caked up and dirty. Are the burners stainless steel or cast iron? Cast iron lasts longer, and tends to get smaller in flames when it's seams corrode shut. Plus it is easier to clean. Stainless steel tends to corrode and fall apart, causing flare ups and unsafe use. Douglas

Is your regulator OK? sounds like not enough gas pressure getting to the burners.

Yes, the model and serial number is below the grill. My burners are also corroded. I have a natural gas with three burners, rotisarrie, smoker. It is also a 36". My # is ZGG36N31YSS. I have seen the YSS be CSS for propane grills. Hope this information helps :) If it does, I have found two sites with the burners; partsadvantage.com and appliance-parts-warehouse.com.

Run around $120 for one burner :(

try this site http://www.stovepartsplus.com/Merchant5/merchant.mvc?Screen=CTGY&Store_Code=SPP&Category_Code=BBQBURNERS

I had the same problem, the burners were corroded. The only way to fix temporarily is to take them out. Once you take them out take out the screw and cover on the end that goes into the gas and try to shake out the rusted parts.