Hello,
The error code of 6500 is a PCI bus error and this is a Service Error Code.
Typically this is an internal error of one of the ASIC chips on the logic board and
can only be repaired by replacing the logic board.
PIXMA MP530
Linke to manuals, and free Canon telephone number and email support.
SOURCE: Error 5100 for canon mp530
I would do all of the following and see if yo can clear this code. It is not on any Canon list of possible codes, so I have no idea what it means., but let's do this:
Turn off the printer and unplug it.
Remove the print cartridges. Look at them, are they leak free? Look into the cartridge holders. Are they clean?. Dried ink or blobs should be cleaned off with a little alcohol and a qtip.
Are the little wire holders bent or broken? Do they look exactly the same?
Turn the printer back on reinstall the cartridges.Check in your printer preferences/services and clean your cartridges.
Now turn it off again and unplug it. Open the paper jam door and gently push the paper roller forward until it clicks. At the same time, look for even the tiniest scrap of anything in there.
Close the paper jam door and plug your printer back in. Restart your computer.
If the problem is not solved. You may need to reinstall the printer. Do You have your original disc? Be sure to do a clean install. ( Turn off all running programs in the lower right corner including your virus control. Also go to Toolbar>tools>internet options>general>and delete all you cookies and temporary internet files.) Turn off and unplug your printer.
Reinstall the software. When it is finished if it has not told you to plug your print back in do so now. Restart your computer and turn your printer on.
I hope this helps. Good luck to you.
SOURCE: I have a Canon PIXMA MP530 printer and showing an
disconnect it from power for 10 minutes and also check for jammed paper. That should do the trick
Rob
Ps. Thanks for ratings.
SOURCE: canon mp530 pixma check printer
It may be the cartridge...try removing it and then reseating it. If that
doesn't do it, clean the contacts with water or isopropyl
alcohol.(power off when you do this)
maybe this forum will explain more
http://www.fixyourownprinter.com/forums/laser/13864
Troubleshooting
>
An Error Code
Is Displayed on the LED
>
Power Lamp
Flashes Green and Alarm Lamp Flashes Orange Alternately
(go down the page until it says:
Power Lamp Flashes Green and Alarm Lamp Flashes
Orange Alternately
)> then look for the error code. good luck!!sorry, the system is printing the same font as the book.
183 views
Usually answered in minutes!
×