Dgx506v with new battery it cut on & goes back out!!

remove alarm reinstall after fitting. at least cut power supply and back up supply fit battery repair reinstall alarm.

The red one goes to the positive. the other one goes to Negative on the battery.

I was able to replace the original NiCad AA batteries with a NMiH 2.4V 1500mAH (3.6 Wh) cordless phone battery Uniden BT-1015. Take out the three screws holding the back on. loosen the battery clamp, slide out the old battery and unplug it, cut off the plug on the new battery, strip each wire about 1/4 inch, push the new wires into the old wire plugs maintaining color, black to black, red to red, fasten new battery under battery clamp, adjust new battery so back of case goes on, fasten back on with original screws, charge new battery with original battery charger over night. I got my new Jensen brand battery at Meijers.

it might be one wire it might be cutting out so you should cheek the wires same of the cars do that

My 1987 buick centry limited cuts off when i drive but when i start it back up it will start right bacc up at times some times it starts and die agin but when it dies the battery light and service engine light comes on but once it starts the service engine and battery light goes away and dont do it agine tell it cuts off agine

Be sure to charge the battery first. New batteries are usually not charged when shipped (fire hazard).

does the camera work with the AC power adapter? If it works fine with the ac power adapter the problem is most likely the battery. Not charged or bad.

just cut cable & little ground wire cut them back install on new ends

Hi,

If you haven't put a new, properly charged battery already, do so.

Good Luck and Let me know,

Obe

I dont now about the sound but for the battery is that the ds charge battery is over! if you see backwards you will need to open it and buy a new battery thats all!!!!!! I try it it works

I have the same problem with an apc smart-ups VS 650.

 

New batteries - charge in batteries is good (also tested under load).

 

When AC power fails, no power is supplied to PC connectors by the UPS.

 

UPS self test works fine. UPS does not report any problems via software - Power Management under Windows XP.