I have a CanonPower Shot A1100IS and my pictures when printed are coming out with a red tint. My Christmas pics were terrible. I'm not sure why. Canyou help me?

Dear Kate,
please run the Epson maintenance software and check your printer cartridge.
i think printer head cleaning is the solution.
please run 1 or 2 cleaning cycles and give a try again.
if problem still there its time to go to technician.
regards,
nuwan.

Hi, I'd suggest talking to where ever you get them printed as it's likely a setting on their computer doing that.

I've seen this before and it's usually a sign of a bad inverter or data cable.


Please insure that you are not using any special lighting filters on the camera before making assumptions. You can check this typically by going through the settings while in Camera mode.

If there are no filters on, you might have a bad camera. Take it back to where you bought it if it's still under warranty. If not, you can call Canon but in most cases the cost to repair a camera exceeds the value depending on how much you paid for it.

Good luck!

Sounds more like the print driver settings are set out of normal. Either set it back to default, or uninstall and reinstall fresh. That would be the first step to troubleshooting. Also check both sides of the carriage rod for a pocket the ink is shot into when it cleans the heads - it may have a build up that is high enough to rub onto the print heads when it parks or cycles, creating a reddish tint.

The Phillips are famous for the coolant needing replacement in the blue and green CRTs which make the screen take on a red tint and the pic will appear dull. You can get the Phillips coolant Kit at www.tvrepairworld.com The kit also contains the CD with instructions

CCD FAILURE !

actually when it starts it starts like this pics with red or purple shades , noise ,distorted, blurred pics , discolored then it goes completely black

dont worry just call Sony for free repairs it is a manufac fault in thousands of cameras with different brands just call sony about ur problem PLS RATE ME FIXYA for help

Sony has issued service advisories for these problems

http://esupport.sony.com/US/perl/news-item.pl?mdl=DSCT1&news_id=161

see this

http://www.imaging-resource.com/badccds.html

I am not an expert with Zodak but you can go to their website and they have a solutions and repair section hope this helps you.

http://www.kodak.com/eknec/PageQuerier.jhtml?pq-path=10/7895&pq-locale=en_US

I discovered I had switched photo paper in the process. The new paper obviously isn't compatible with this printer. I went and purchased more of my regular paper and the pictures began printing well again.

hello sir , my problem my mobile cam not open ( camera module not ready )

Please de active the redeye option on your camera setting.
And restore the factory setting and turn off camera for 5 minutes after this use it.

Hope its helpful to you