How to check your load balance in smart - Cell Phones

Probably washer is smart enough to detect the out of balance.
Try to distribute the clothes in a balanced maner as soon as you detect it is out of balance.

Do you have lights 3,5,7 and 8 on when it's beeping
It's error code 43.
43. (00101011) Phase 1 to 6 - OOB Switch Fault
The Motor Controller module has found that the signal returning from the out of balance switch indicates that the switch is permanently
on or the harness to it is disconnected.
Primary Source: Mechanical.
Action:
1) Check that the out of balance switch is free to move.
2) Check that no harnesses are blocking switch movement.
3) Check that the switch operates correctly when activated.
Replace the switch if suspect.
4) If the out of balance micro switch shows signs of corrosion,
replace the switch and switch harness,
5) Check the level of the machine and also the bias spring.
Secondary Source: Wiring.
Action:
Check the harness to the switch is connected correctly.
The terminals should be connected to the normally closed position.
If the harness terminals show signs of corrosion,
then fit a new harness.

Since you still have the Prepaid load card please contact Smart telecommunication companies contact center at *888 or (02) 888-1111 and tell them that you have just reloaded the number on the card with the pin. And they will re verify that for you.

The stainless steel bowl has lost its ballast water & goes out of balance,Replace faulty bowl.

Check the out of balance switch under the blue motor controller
for corrosion replace if corroded.

Check if you can check you load balance. If not then the cellphone is having problems. Also check if you can make and take calls. If all else fails, call *888 for smart customer service.

The part that needs to checked and/or replaced if necessary is the out of balance switch assembly. Either the switch is welded together and doesn't trip for the machine to cut out when an out of balance condition occurs or the switch lever is damaged or dislodged. The out of balance switch is located on the right hand rear corner of the cabinet. Lift the top cover up to access and check the out of balance switch which part number 420313.

Error Code 43 means OUT OF BALANCE SWITCH FAULT.Is your model an ECO smart model?Have you or can you borrow an electrical test meter to test the OUT OF BALANCE SWITCH?Please reply with additional information and I am sure I can help you rectify this fault.

My Advice?
Don't even try!........anyone that thinks that it is smart to keep on using a machine that leaks is not only dicing with death by electrocution, but also has a mindset that this experienced Techo would suggest does not make them a good candidate to tackle a repair.

There are 2 ways to reload your Smart Bro load card:

1. Buy a Smart Bro Load Card, then using any Smart GSM cellphone, text: Reload <PIN><Smart Bro Prepaid number> and send to 1510.

You will receive an SMS from 1510 showing the updated Prepaid balance. In addition, you will receive another SMS on your Smart Bro modem message inbox confirming load receipt.

2. Go to a Smart Load retailer.