I cant find any drivers for hp laserjet m1522nf mpf fo in oder to make it scan,as well as the EWS,Nad fax drivers

Download the driver from the HP website for Windows 7. I have attached the link for the 32 bit Windows Driver. http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareIndex.jsp?lang=en&cc=us&prodNameId=3442754&prodTypeId=18972&prodSeriesId=3442750&swLang=8&taskId=135&swEnvOID=4062

The original disk is just to old to use for the newer operating systems.

HP Laserjet M1522nf Update 7 drivers

I have problem with my MFP 1522nf Printer I cant recieve fax on incomming call it is quite dead while It is set in automatillay answer mode when I dial it dial and gives tone but while in comming call no rings no reply ring answer mode is 1 but quite I checked every way settings wires but cant understand can any one know about this and help me.

My email [email protected]
Thank you

Hello, if you go to the reports menu from the control pnel, then to the fax reports sub menu.

From there you cn setup all of the confirmations required.

Hi Mechanic.

The problem could be with your phone service if you are on digital lines, you would have to install a digital to analog filter. If you are analog the comm errors are typical of a line with a lot of static. You can change two settings on the printer which should solve the issue until you install a filter.

The two settings which are under the fax set up menu/ all faxes\
Error correction mode (ECM) set it to off
Fax Speed set it to medium.

Good luck

Al
[email protected]

install full software, download from www.hp.com

the Error is "the software had trouble scanning or was cancelled" in HP printer 2727 MFP please advice

Try rerunning the installation disc, you will find and option that reads "install more software, install this a restart your computer

Go to HP as per attach link http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=18972&prodSeriesId=3442750&prodNameId=3442754&swEnvOID=228&swLang=8&mode=2&taskId=135&swItem=ma-56725-2 and download the software. After extract it to another folder, and click install. Voila the printer now work like a charm.

Hi,
If your printer is connected in the Network and you are able to print fine than there is no communication Error.
In htan case if you are not able to scan then you need to upgrade the firmware of the printer and install it and i m sure your printer wiill scan scanning on the Network.
Mentioned below is the link to download the latest firmware of the printer.

http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=18972&prodSeriesId=3442750&prodNameId=3442754&swEnvOID=228&swLang=8&mode=2&taskId=135&swItem=ma-70811-2

However before you start sending firmware to the printer you need to make sure that printer driver is installed on the PC.

Thanks and Regards
Neeraj Sharma