My Element Flatscreen works sometimes. I can turn it on and it might work for 5 min or 5 hrs but it will eventually turn of with a sordof click sound like when you turn it off yourself. Once it turns off it will stay off indefinately unless you unplug it. then when it feels like it it will turn back on once plugged in. could be 5 min, 1hr or 3 days. What does that telll you?

There is a dry solder and this might require attention by a qualified service technician.

Hi Dennis.

If the dishwasher is hanging on in the middle of the cycle it is usually the heating system. If the temperature of the water is going up after filling, then the element may be working. The element is tested using a multi meter set on Ohms to read impedance across the heater element contacts. If impedance is infinity (open-off limit), then the element is gone. If the element is OK, then the bi-metal thermostat or the fuse must be replaced. The heating assembly is located at the base of the appliance, behind the kick panel.

Behind the kick panel you should also find the tech sheet illustrating how to run the diagnostic cycle for this model. Run a diagnostic cycle to confirm that the problem is with the heating system. Drain, water sensor and inlet problems sometimes may also result in cycle not finishing.

You can find parts and diagrams for your dishwasher in this page.

Regards.

Ginko

Hello,

The problem is that there is a bad capacitor on the power supply board of the television, it is still turning on because it is not yet completely bad. While it tries to respond is when you get the clicking sound, therefore it is going to keep acting that way until the bad capacitor is replaced.

Run a check on the power supply board, you will definitely see the bad capacitor, have it replaced and the television will turn on after reassembling the television back together.

Thank you for using fixya
Caseytech

A tv this new probably has a warranty. Take it back and let them fix/replace it. It's their headache with the warranty.

defo a heating element fault or an ntc fault. More likely to be the element though.

I was going to suggest that maybe it is a self defrost issue not shutting off when it should but sine you mentioned this knob, it suggests a thermostat out of calibration - I can rule out circuit problems since you can manually turn on compressor by turning the knob to a cooler position - you will need to have it serviced and change the thermostat which is not cycling whne it's supposed to.

ALSO - do not refreeze foods in your freezer that have thawed ! Throw them away !!! Normal freezer temps should not be warmer than 10F, the normal temps are 0F, and optimal recommended temp -10F (for hard ice cream) and to allow better recovery in case of power failures.

Refrigerator section no warmer tan 40F.....optimal recommended 34F.

right click on desktop.go to properties.in properties go to the screen saver tab.under the screen saver tab u will see something called power.click on power.change the settings of the monitor there.let me know if it works

the actual proble is in the BCM which means body control module, i will first check and make sure that all the grounding cables to this vehicle is tight and clean and if they areok and the problem continues it is time to get a new or rebuilt BCM.

Was talking to one of the experts on the "chat live now" tab and he suspects a power supply problem. Who knows??

Replace C953 1000mf / 35v in power supply....capacitor
top will appear slightly bulged or will check bad with
ESR meter...........................T.