Siemens Speedstream Modem 6520

run a diagnostic and see what the problem is if it does not say then consult somone online.

Dear yohwayne

I am afraid that there are incompatibilities between speedstream 6520 and Voip service. I will need to look at this a little bit further but I think the only workaround is a firmware update. (modified version of the original)

Regards
EngineerGR

do resetting the router, and reinstall again the network adapter on your laptop.

hope this helps

This router is designed to be connected to your computer . Your drives are also connected to your computer. But you can set up a LAN to access your other computers and/ or drives on a network

speedstream is a modem/routerwirless unit. you can't connect a modem to a modem. use either one not both.

Yes.Get rid of it.I have a Satellite also and do agree configuration was dodgy at first but the range in Wi-fi was not even 50 ft. as opposed the 100 ft. promised.But finally,after it shorted out my dial tone like most other 6520's I just went back to my trusty speedstream 4100.Good-luck.

um not sure, but if you have the disk that came with your router run it and fill in the wireless wizard. Also, on my 6520 the "wireless" led doesnt light up unless i have a device connected that is wireless. Your laptop may be incorrectly setup

hi, XBRMann
re 6520 seimens wireless modem
i have DSL internet connection
when the phone call dies i hang up the phone and call again for the same amount of time 3mins and 18 secs
i am using the seimens modem/router with the voip adapter connected via ethernet cable
i have updated the seimens modem/router with the latest firmware from the telstra site E752-AF5-106-71-a056-v1s
lkratzma

messege me on aim for me to walk your through step by step. Copter64

Hi,

* You dont need any special drivers to install modem.
* Open up internet explorer, type 192.168.0.1 in the address bar and press enter key.
* Now you should see the configuration page of modem.
* On the left side, click on Advanced button, below that, you will see "connection configuration" option - click on it.

*** If it asks for modem access code anywhere, you can find the code underneath the modem. please type it ***

* Under this page, you have to enter the email address in username field and password, change the connection type to smart keep alive, click on save changes

* Now it may ask you for restart modem. click on restart. within 1 min, you will be connected to internet.

Take care