Im trying to hook up my gaming console to my insignia 19" tv. im using a vga cable. when i go to the vga channel i got a message saying "not supported"

call you digital cable provider

It could be as simple as your video cable going bad. Check to make sure the wire is in good shape and that the contacts and connections are secure.

I would say try using it with an HDMI cable (if possible) and see if the problem persists. You can also try and hook up another device (DVD player, camera, PS2, etc) to the TV input you are using now and see if it is the TV that is giving you trouble.

Hey there!
Is there a button on the set or remote that says "input" or "source"? That will change the input settings from cable, to HDMI or RCA (aux).

Does your TV not have a PC connection? It looks like and IS the same as the Connection on your PC. If so, get a standard VGA male to male VGA connector cable from your local PC shop and use this. The adaptors you are using won't be seen as PC input. You will need to also connect a PC audio cable between them to get sound. When you have installed these, using your remote control, select "scource" as PC and you should be away! Good luck. Ian.

i have a 26" insignia lcd tv that i use as a montor uou musr set the screen resolution on your computer to 1024x768. if you use a higher resolution it will say no signal.so use your montor to set the resolution to 1024x768 then hook it to the vga and it should work. bob griggs

Heres the dealyo.
Click start button
Click control panel
Click display
Click settings
adjust screen resolution (probably have to go down) until the tv displays your computer
if this did not work, you will have to adjust bit rate from 32 to 16. Fiddle with the settings until the magic happens.
You will not get any sound unless you use an audio jack plugged into t.v.

Im here all week

help

USE a VCR between the PS2 and the Sylvania TV.  Hook the PS2 A/V cable RCA connectors( Red, Yellow, White) to one of the the Video input RCA connectors( Yellow, Red, White) on the VCR. Hook the VCR Cable output to your Sylvania Cable input. Set the Sylvania Tv to channel 3 or 4.  Set the VCR channel to Line 1 or Line 2.  This should work. I hope it helps you.

in some cases certain manufacturers say in the instructions that when using s video with seperate audio, you cannot use the HDMI for the sound and sometimes visa versa, it's just the way the output is set up. Remove the other sound cable you are using for pc or tv and just use HDMI to confirm that the sound is re-enabled on the HDMI

problam can be with cable, screen, or xbox. try replacing cable first, it is the cheapest and therefore can save you alot of pain. if another cable doesnt solve it, try hooking xbox with another screem (TV or something), if it works, its a screen problem - check for overheating. if it doesnt, you got yourself a messed xbox im afraid.