Question about Tappan Ovens

1 Answer

My 30 year old wall Tappen oven, the pitot is lit but no gas comes through to lite oven.

Posted by mjk1220 on

Ad

1 Answer

D. Floyd Kolb

D. Floyd Kolb

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points
    Superstar:

    An expert that got 20 achievements.
    All-Star:

    An expert that got 10 achievements.
    MVP:

    An expert that got 5 achievements.

  • Tappan Master
  • 43,501 Answers

Hi,

The ignitor is not working right and is going bad....
have the repair man replace the ignitor, or DIY....
Check out this tip about your problem...

Oven not Working or Oven not Heating

Oven Problems Replacing the Igniter

heatman101

Posted on Mar 07, 2011

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Kenmore wall oven 3052
most likely the igniter is not working at 100% and the gas valve won't open unless it is at 100%. Replace the igniter first.

Aug 12, 2014 | Kenmore 24" Manual Clean Wall Oven 3052

1 Answer

Maytag gas oven takes a long time heat and smells of gas.
Important---if you smell gas--I'd be very very careful---could be your control valve or lines to it are malfunctioning or leaking. You might have to call in an expert repair person. How old is the oven? Some preliminary checks you might make are: Do you have a pilot lite or preheaters on the unit? If a pilot lite, make sure it is lit. An unlit pilot lite could sometimes give the smell of gas if malfunctioning. If so, there is is a procedure for lighting the pilot lite--check your user or installation manual. If you have pre-heaters make sure they are lighting up. Normally you have one for the top broiler burner, and one for the bottom oven burner. Check your preheater(s) by selecting either broiler or oven and visually checking to see if they are warming up. After 15 seconds or so, they should be turning bright red. You will see some light coming from them. Check one pre-burner at a time. If they do not come on quickly, shut off the associated valve. Again, be very, very careful with any buildup of gas. It could cause an explosion. At the least it could make you sick.

Sep 12, 2012 | Maytag Ovens

2 Answers

I have a caloric oven, prestige series. Don't know model. it is about 15 years old. last year the oven wouldn't heat and smelled gas. That was repaired. Now, oven ignitor comes on but oven...
Hello,

The ignitor is bad again,if it (ignitor) comes on but no flame/heat its the ignotor again, what would make the ignotor go bad so fast (usually last 10-15 years) is a problem with the oven burner, so now BOTH the ignitor and burner would need to be replaced,if it is 15 years old the ignitor is readily avaliable but the burner may not be

Gene

Aug 04, 2011 | Ovens

1 Answer

Hello. Is there a flame sensor on my Whirlpool Accubake 465 oven? Once the oven heats up to say 350 degrees, it shuts off. When the temp goes down, it re-lites to get back to the 350 degrees. It starts...
Good Morning! Do you have the model number of your appliance? With that we can better assist you.
Thank you!

May 14, 2017 | Whirlpool Ovens

1 Answer

Tappen oven lites then goes out after 30-40 seconds
The problem is the igniter not reaching the correct amp draw .When the igniter does not reach the correct amp draw it may allow the gas valve to partially open or not open at all. The igniters are inexpensive and easy to replace. There is a video at http://appliancehelponline.com/gasoventroubleshootvideo.html this will walk you thru the correct procedure for performing this test. It may be a different model but the testing will be the same.You can also enter your model # for diagrams and illustrations of your specific model. Not all models are available. All parts come with installation instructions.

Jun 04, 2010 | Ovens

1 Answer

Kenmore gas oven does not reach operating temperature
If your oven is 20 years old the temperature sensor system might no longer be accurate, if you have access to a temperature measuring device that can confirm that the oven is not reaching 350 then run it up and check that its not just your indicator light system. Some oven burners have air control and yours may have accumulated oven soil over the years. If your burner. Is behind a short wall like mine is, use a mirror and torch to check. A clean can bring things back to standard. Flame heat is from a good mix of. Gas and Air...

Dec 05, 2017 | Kenmore Ovens

1 Answer

Gas oven(tappen) with broiler draw. oven will not light, no pilot
if this is fairly new, there is a hot surface ignitor near the back of the burner in the bottom part of the oven. This can go bad. There is a connector that can be pulled apart where the ignitor meets the wiring harness. Ohm out the ignitor or have someone with a meter ohm it out. There should be resistance and not open. If open the ignitor should be replaced. If you have a broiling element, turn that on. If the broil element comes on then the ignitor is almost for sure the problem.

Nov 21, 2009 | Ovens

1 Answer

The pilot light works and gas in oven is on, but no gas ingition
bad thermal bulb, try moving the bulb into the flame more.

Jun 25, 2009 | Ovens

1 Answer

We have a kenmore wall oven and we need to know how to relight it. it is g a gas oven.
your oven lest its very,very old dose not have a standing pilot.it lites by demand when you turn on

Jan 01, 2009 | Kenmore 33464 / 33465 / 33469 Gas Single...

1 Answer

Kenmore Gas Oven not working
IT POSSIBLY DOES IF SO IT WOULD BE UNDER TH BOTTOM PAN USUALLY IN THE BOTTOM OF THE OVEN , YOU WILL NEED TO LIGHT IT WITH A MATCH (AFIREPLACE MATCH WORKS BEST ) LET BURN FOR A FEW MINUTES TO MAKE SURE IT GOING TO STAY LIT BEFORE YOU TRY THE OVEN .

Nov 26, 2008 | Ovens

Not finding what you are looking for?

View Most Popular

Ovens

Related Question

Kenmore wall oven 3052

  • Kenmore 24" Manual Clean Wall Oven 3052

Open Questions:

0 Answers

Tappan self cleaning. Oven door locked while open. How can it be unlocked to close?

May 26, 2019 | Tappan Ovens

0 Answers

i have a old tappan 24 inch wall oven that i need to replace the door gasket and the number on the door is 11-1668-30/0115618232516 model number or the parts number for the door gasket thanks

May 22, 2018 | Tappan Ovens

0 Answers

I need the manual for tappan electric wall oven FOVV 226 There is no eletricity getting to the ovens so they do not work

Feb 05, 2015 | Tappan Ovens

0 Answers

I have tappan oven/microwave combo model# TEB794BBBA and the microwave takes longer to heat foods than it use to. what is the cause of this problem?

Nov 29, 2013 | Tappan Ovens

Ovens Logo

Related Topics:

176 people viewed this question

Ask a Question

Usually answered in minutes!

Popular Questions

1 Answer
F10 fault on tappan range

Tappan 30IN ELEC IGNa Oven

3 Answers
Tappan Electric Oven

Tappan 30IN ELEC IGNa Oven

1 Answer
Tappan Gas Range Pilot light went out.

Tappan 30IN ELEC IGNa Oven

2 Answers
Tappan electric stove designer series

Tappan 30IN ELEC IGNa Oven

2 Answers
The pilot light for the oven went out.

Tappan 30IN ELEC IGNa Oven

Top Tappan Ovens Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

john h

Level 3 Expert

23515 Answers

MODERATOR Canada
MODERATOR Canada

Level 3 Expert

36602 Answers

Are you a Tappan Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...