Infer red light comes on but can"t see anything no

could be a dead remote test with a camera ie phone. look at camera on phone etc wile looking at the remote with the camera press the button if working there should be a light coming from the remote. if not the the inferred led may have gone in the remote easy to replace it is just soldered in. take batteries out of remote. there maybe a small screw in the bottom were the batteries sit. take that out. the with a flat blade on the gap between the top and bottom of the remote on the side. use a flat blade minding your hand etc wile doing this. and pop the cover off. when you have done this there is a led at the end of the remote. replace that with the same size ir red led and put back together remote should be working again.

Green is not coming on as either a issue in the set's power supply or something connected to it---that simple--called shutdown.

Unless you know what you are doing likely better to take it to the shop
for an estimate of repairs.

Tries take both remotes controls pushes all the funsctions butons one by one on the front of a turn on Digital Camera,see if u will able to see all the INFER RED signal white light will flashing on the Digital Camera viewing screen.To make sure both the remotes are working and all the buttons are have INFER RED light signal out.Tries pushes all the tv manual buttons on the tv side too see if it is funsctioning too.If all these work testing work,than take some rubbing alchahol put on a rag clean the INFER RED sensors signals on the tv an the cable box by the tv power light LED indications lights.Tries these steps,make sure tv manual control tv side panel work and both remotes works and clean both INFER RED sensors on cable box and tv make it work better.Unplug the cable box for an hour for it to reboot and updating it softwares.Replug the cable box and now tries the tv remote or cable remote again,should functions now.

Test ur tv remote control first see,if it is working,malfuctions or completely dead?U have a Digital Camer wright?Yes.Digital Camera can read Infer Red signal Output by the tv remote.Yes?Turn the Digital Camera on and take the tv remote point it at the Digital camer and pushes all the remote buttons the Infer Red signal will read all buttons Infer Red signal flashes u can see on Digital Camer viewing screen.Pushes all remote buttons see flashes of white lights.Mean the tv remote control it it good or not.Take some cottons ball soak it with some rubbing alchachol clean the tv Infered Red sensor on the tv frame near the power LED incation light.Might be dirty,Still not reading the Infer Red signal.If 100% it is the tv remote control is the cause,it CPU is dead.Try website like Remotes.com to buy another the tv original remote.

Your set is still under a manufacturer warranty. Take your set back to Wal-Mart and they will send it out to be repaired, or give you a new one.

there is a pump filter in the bottom front right side get a screw driver pop the cover off unscrew the plug/catcher & clear anything out thats in there and if it still doesnt work the pump has probably failed.

the infer red sencer could be playing up

If you have water sitting in the trays and no action is happening, then i suggest replacing the ice maker complete as these spares are pricey and take a while to get to you , (In the hope that they are correct). On some units there is a small test button. If you have one, push or switch it to activate icemaker. Often this resetting brings the ice maker back on line.

got a replacement TV

Hi,
Before sending your phone in for a flash or attempting to do it yourself (wotanserver), I would suggest the following. Take out the battery and leave it out overnight. Then put it back in the following day and try turning the phone on. If this didn't help, then flashing is required. You can try flashing with SEUS (Sony Ericsson Update Service) which is free (wotanserver requires credits=money). Good luck!